User manual

APPENDIX C: AIRCRAFT CONFIG NOTES
(number is default)
¿ animEngineRPMMult 1000 - Rotate the Prop dof this many times the current rpm (rpm is 1.0
at Mil power).
¿ animSpoiler1Max 60.0 - Spoiler extends this amount at full deflection.
¿ animSpoiler1Rate 45.0 - Spoiler moves at this rate
¿ animSpoiler1OffAtWingSweep 70.0 - If the a/c has swing wings and the wings are swept
past this, then the spoiler is disabled.
¿ animSpoiler1AirBrake 1 - Spoiler acts as airbrake
¿ animSpoiler2Max 60.0
¿ animSpoiler2Rate 20.0
¿ animSpoiler2OffAtWingSweep 45.0
¿ animSpoiler2AirBrake 1
¿ animExhNozIdle 0.0 - Drives Exhaust Nozzle DOF based on engine RPM.
¿ animExhNozMil 10.0
¿ animExhNozAB 0.0
¿ animExhNozRate 5.0
¿ animStrobeOnTime 0.02 - Drives new strobe light code, light is lit for this amount of time
(atleast 1 frame)
¿ animStrobeOffTime 1.0
¿ animHookAngle 0.0 - Drives Tailhook DOF
¿ animHookRate 0.0
¿ animAileronRate 45.0 - On a/c with Ailerons, this is now used instead of tefRate.
The swing wing code uses a table to determine where the wings should be swept to. Each
..MachX line specifies the minimum speed at which the corresponding ..AngleX is applied. For
example, the plane has to go at least .6m for the wings to be swept back 25 degrees. Also, don't
confuse these angles with real world sweep angles. (ie consider that the LODs have their wings
swept to there minimum position, that might be 15degrees in RL, but is 0 inside the code).
¿ animSwingWingStages 2
¿ animSwingWingMach1 0.6
70