Owner’s Manual m t x .
INTRODUCTION BEFORE STARTING This next generation JackHammer subwoofer continues to prove that MTX is the biggest, baddest, boldest car audio...ever! • Fork Lift (or another means of lifting approximately 370 lbs.) • Electric drill • 5⁄32" drill bit • Safety glasses • T-30 Torx • Six 5⁄8"-11 bolts 1 3⁄4" long • 15⁄16" wrench or socket SPECIFICATIONS Thank you for choosing MTX to help you reach your ultimate goal with your vehicle.
RECOMMENDED ENCLOSURE REQUIREMENTS For Sealed Enclosures The JackHammer requires a volume of 5.47 cubic feet (net) per woofer. The woofer’s displacement is 2.06 cubic feet. The total gross volume will be 7.5 cubic feet. For Vented Enclosures The JackHammer requires a volume of 10.2 cubic feet (net) per woofer. The woofer’s displacement is 2.06 cubic feet. The port’s internal dimensions are 26" x 5" x 15" and it takes approximately .5 cubic feet. The total gross volume will be 12.3 cubic feet.
MOUNTING Mounting the TS9924-22 JackHammer is nothing that can be taken lightly, quite literally. You need to follow the steps below carefully and have all the necessary equipment. You will need to be able to lift the nearly 400 lbs. subwoofer comfortably. MTX Audio recommends a fork lift or engine hoist for safe installation. WIRING OPTIONS Often overlooked, the installation components used to connect the entire system need to match the maximum capability of the system or you will lose performance.
TS9924-22 wiring setup This figure shows the recommended amplifier connection for the TS9924-22 using the MTX TE4001D amplifier. CA P+ +B AT T 4 AWG 1/0 AWG 16 AWG 1/0 AWG 4 AWG Amplifier’s main power terminals RE M -GN D CA P- PISTON CHANGE (RE-CONE KIT) Since the installation of the JackHammer is a large investment in time and resources, the cone can be removed without removing the entire sub or enclosure. Re-coning the woofer is surprisingly easy.
NOTES: RED INSULATION VC1 + USE 3MM HEX KEY TO LOOSEN SET SCREWS TO INSTALL TINSEL LEADS USE 4MM HEX KEY TO LOOSEN SET SCREWS TO INSTALL WIRE (12 EACH) 1/4-20 X 1-1/4" SOCKET CAP SCREW STEEL WITH BRIGHT CHROME PLATE HEX SOCKET SIZE 3/16" REMOVED THESE TO TAKE THE GASKET OFF FOR RE-CONING BLACK INSULATION VC1 - RED INSULATION VC2 + BLACK INSULATION VC2 - (12 EACH) 1/4-14 X 3" TORX SOCKET HEAD STEEL WITH BRIGHT CHROME PLATE T-30 TORX DRIVE USE THESE TO MOUNT THE WOOFER (IF WOOFER DOESN'T NEED TO BE REMOV
© 2009 Mitek Corporation. All rights reserved. MTX, Thunder, JackHammer and StreetWires are trademarks of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 1 Mitek Plaza, Winslow, IL 61089 U.S.A. MTX003284 RevA 6/09 21A9241 m t x .
