User Manual

MTX.COM

Remove the bolts from the C-bracket so the top

bracket and C-bracket can be properly positioned around the roll cage.

Once the C-brackets are in the proper location for mounting, the bolts

should be retightened to a torque specification of 65-70 inch/lbs.

The unit has an integrated wiring harness that includes a power, ground, and accessory wire that

are designed to connect to the vehicle’s battery providing it power. The wiring harness is 3 meters

but can be cut to fit the individual vehicle. The fused yellow loop should be cut at least 2” from the

fuse holder and the short end should be coupled to the yellow power wire once it has been run to

the area where the battery is located. The other end of the yellow wire is designed to be connected

to the positive (+) terminal on the vehicle’s battery using one of the included ring terminals. The

included 15A fuse and fuse holder should be attached to the yellow wire no more than 18 inches from

the battery to protect against damage or injury if a short in the wire were to occur. The black wire

is designed to be connected to the negative (-) terminal on the vehicle’s battery using the second

included ring terminal. The red accessory wire needs to be connected to the accessory switch. This

ensures that the unit powers on when the vehicle is On and powers Off when the vehicle is not being

used.

Fuse Holder

Butt Connector

to MUDSYS

Ring Terminal

Cut fuse holder wire

in the center.