User Manual

MTX.COM
6
CLOCK OPERATION
Press and hold the “Band” button for 2 seconds to display the clock. When displayed, press and hold
the“Band”buttonfor2secondsuntilthehournumberisashing,thenusethe+/-buttonstoadjust
the hour. Once set to desired number, press the “Band” button again and the minutes number will
ash.Usethesameprocesstosettheminutestodesirednumber.
INSTALLATION
The MUDSYS31, MUDSYS41, and MUDSYS46 will mount to a variety of roll cages that have a
diameter between 1.75" and 2". Installation is a two part process. Part one involves securely mounting
the unit to the roll cage and part two involves connecting the wiring to the vehicle’s battery.
Each unit comes preassembled in the carton. Each end
hasatopsideatbracketandanundersideC-clamp
designed to lock the unit into place between the roll
cage. Each top bracket has four (4) total bolts.
When the bolts are loosened, the bracket can slide
to accommodate a variety of roll cages whose inside
roll bar dimension is between 32.25" and 38.75" for the
MUDSYS31, 43.0" and 49.0" for the MUDSYS41, and
49.25" and 56.0" for the MUDSYS46. Once the proper
width has been established, these bolts should be
retightened to a torque specification
of 40-45 inch/lbs.
Each C-bracket has two (2) total bolts. These bolts can be loosened to adjust the clamp angle
allowing it to mount to a variety of roll cages including those that are angled.