Operator`s manual

701333-004 B-31
Programming Notes
Note: Line spacing in n/216 inch (base units value) will adjust the required line spacing
to the nearest 1/144 inch.
Note: After receipt of a spacing command, each LF command or equivalent results in
the line feed distance specified by the spacing command.
Note: Reverse line spacing moves the paper n/144 inch in reverse and requires that a
DOD module be installed. If there is no DOD module, the command is ignored.
Caution
To avoid paper jams, do not use a negative line feed command such as ESC j (n) unless
a Forms Handler module is installed. Refer to Chapter 2 for information on installing the
Forms Handler module.
Vertical Tabbing Commands
Vertical tab stops to control paper motion are set with the following commands.
noitcnuF edoC lamiceD xeH
mroFfopoTteS4CSE257243B1
baTlacitreVetucexETV11BO
spotSbaTlacitreVteS0kn...1nBCSE00kn...1n667200kn...1n24B1
baTlacitreVteseR0BCSE
RCSE
006672
2872
0024B1
25B1
Vertical Tabbing Commands
Note: Up to 64 vertical tab locations can be set (ESC B).
(nk) is an ASCII character with a binary value between 0 and 254 (ESC B).
Sixty-four vertical tab locations can be set within page length.