Operator`s manual

701333-004 4-21
Configuring the 1330 in 3270 Mode
409 – Auto Eject
To make it easy for you to tear off forms, configuration Option 409 enables you to have
an automatic form eject after the 1330 has been idle in DOD mode for an operator
selectable time period. After additional data is received, the form will be retracted. If you
choose 0 (Disabled), the auto eject will not function.
noitpO eciohC gninaeM
904
)delbasiD(0)tluafed(atadfodneehttaruccotonlliwtcejemroF
)sdnoceS(552-1ytpmesireffubehtretfasdnocesnruccolliwtcejemroF
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (0 or 1-255) and press Save.
410 – Full Form Feed Eject
Configuration Option 410 is used to specify whether to use the full form feed eject feature,
which ejects the form from the print head to the tear point in DOD mode.
noitpO eciohC gninaeM
014
)oN(0)tluafed(tcejelamroN
)seY(1sitcejeDODa,desserpsiyektcejE/daoLehtnehW
mrofehtfodneehtlitnudeyaled
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (0 or 1) and press Save.
Note: You can select 1 in any mode. However, if the printer is not in DOD mode, the
alarm will sound to alert you that the selection will not be effective until the
printer is put in DOD mode.
411 – Paper Eject Adjustment
To align the forms for easy tear off, configuration Option 411 is used in conjunction with
the DOD Forms Handler module. This option enables you to adjust the distance the
paper moves when you press the Load/Eject key while the DOD option is installed. Valid
values are 0 through 255. The default is 127.
To adjust the paper eject distance, follow the configuration procedure that begins on
Page 4-1. EJECT ADJUST will display in the status window, followed by the current
value. If you enter a greater value, the paper will eject higher. If you enter a lesser value,
the paper will eject lower. You can keep the current value by pressing Save.