Operator`s manual

4-22 701333-004
Configuring the 1330 in 3270 Mode
412 – Horizontal Offset
Use Configuration Option 412 to set the first printable position on the page. Values range
between 0 and 127. Units are in increments of 0.007 inch (0.02 cm), so the offset is
between 0 and 0.88 inch (0 to 2.24 cm). The default is 14.
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (from 0 to 127) and press Save.
Note: If you go to this feature frequently, you may want to use a shortcut to its options.
Follow this procedure: In Ready mode press the Option key. That will take you
to Express 412, where you can use the arrow keys to select the values as you
normally would. Once you have chosen the values you want, press the Start key
and your setup will be saved.
413 – Horizontal Registration
Configuration Option 413 enables you to adjust the printed line horizontally for vertical
character alignment. Values range between 0 and 255. The default is 127. Units are in
increments of 0.0007 inch (0.002 cm). Note that this option is used with bidirectional
printing only. For complete instructions, refer to “Checking Print Registration” in Chapter 7.
414 – Paper Jam Sensor Enable
Use Configuration Option 414 to enable or disable the paper jam sensor. If you specify
NO (by entering 0), the paper jam sensor will be disabled.
noitpO eciohC gninaeM
414
)oN(0delbasidsirosnesmajrepapehT
)seY(1)tluafed(delbanesirosnesmajrepapehT
To specify your choice, follow the configuration procedure that begins on Page 4-1.
Enter your choice (0 or 1) and press Save.
415 – Paper Out Sensor Enable
Configuration Option 415 enables and disables the paper out sensor. If the paper out
sensor is disabled, the alarm is prevented from sounding when the printer is out of paper.
Caution
When the paper out sensor is disabled, the printer will not be able to detect a paper out
condition. If the printer continues printing without paper for an extended period, the
print head could be damaged.