MUD100.2 10 0 WAT TS x 2 RMS 2 CHANNEL AMPLIFIER OWNER’S MANUAL MUD100.2 AMPLIFIER Use your smartphone to scan or visit youtube.com/user/MTXAudioUSA to learn how to properly install this amplifier. MTX.
PRODUCT INFORMATION Model # Serial # Dealer’s Name Date of Purchase INTRODUCTION Thank you for purchasing this MTX Audio Hi-Performance amplifier. Proper installation matched with MTX speakers and subwoofers provide superior sound and performance for endless hours of enjoyment whether you are waking the neighbors or just out enjoying your tunes.
PANEL LAYOUT 1 WHITE: L+ BRIDGE+ WHT/ BLK: L– GREY: R+ GREY/ BLK: R– BRIDGE– RED: 12V+ BLUE: REMOTE BL ACK: GND 2 3 LE VEL X-OVER FULL HI LOW MIN MA X MTX.
WIRING DIAGRAM See page 22 for amplifier wiring diagrams. INSTALLATION AND MOUNTING MTX recommends your new Thunder Sports™ amplifier be installed by a 12 volt installation specialist. Any deviation from specified installation instructions can cause serious damage to the amplifier, speakers and/or vehicle’s electrical system. Damage caused from improper installation is NOT covered under warranty. Please verify all connections prior to system turn on. 1. Disconnect the vehicle’s negative battery cable. 2.
INSTALLATION For proper perfomance and safety, MTX recommends installing an inline fuse per the owner’s manual instructions according to the following. MUD100.
SPECIFICATIONS Model MUD100.2 Description 50 W RMS/CH Stereo RMS Power at 14.4V 41 Bridged Load 200 W RMS 21 Load 100 W RMS 41 Load 50 W RMS Features Input Level 0.2 - 5V Frequency Response 20Hz - 20 kHz Low Pass Filter (LPF) 80Hz Fixed High Pass Filter (HPF) 80Hz Fixed THD at 41 , 1W <0.2% Signal-to-Noise Ratio >85dB Minimum Load 21 Low Voltage Protection Yes, Protect <8V Components & PCB SMD Parts / Double Sided FR-4 PCB Dimensions 6 Height 1.61" (40.9mm) Width 5.71" (145.
WIRING DIAGRAM 41 Stereo WHITE: L+ BRIDGE+ W H T/ BL K : L – GRE Y: R+ GRE Y/ BL K : R – BRIDGE – RED: 12 V+ BLUE: REMOTE BL ACK : GND RCA Signal RCA Signal Remote Signal FUSE 4-Ohm 12V Source Unit 4-Ohm 22 MTX.
WIRING DIAGRAM 21 Stereo WHITE: L+ BRIDGE+ W H T/ BL K : L – GRE Y: R+ GRE Y/ BL K : R – BRIDGE – RED: 12 V+ BLUE: REMOTE BL ACK : GND RCA Signal RCA Signal Remote Signal FUSE 4-Ohm 12V Source Unit 4-Ohm 4-Ohm 4-Ohm MTX.
WIRING DIAGRAM 41 Bridged WHITE: L+ BRIDGE+ W H T/ BL K : L – GRE Y: R+ GRE Y/ BL K : R – BRIDGE – RED: 12 V+ BLUE: REMOTE BL ACK : GND RCA Signal RCA Signal Remote Signal FUSE 12V Source Unit 24 4-Ohm MTX.
© 2014 Mitek Corporation. All rights reserved. MTX is a trademark of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 4545 East Baseline Rd. Phoenix, AZ 85042 U.S.A. MTX004785 RevA 1/14 • 21A10131 • AW0014621 MTX.
+ VOL POWER VOL – OWNER’S MANUAL MUDBTRC BLUETOOTH REMOTE CONTROL MTX.
IMPORTANT NOTICE If you have any questions regarding wire routing in a vehicle, please contact MTX Technical Support at 1-800-225-5689. When connecting power and ground wires ensure that the yellow power wire is fused at the point where it is connected to the vehicle’s battery. Failure to do so can result in damage to the vehicle if a short circuit develops between the vehicle connection point and the product.
REMOTE OPERATION 1. Play/Pause - The Play/Pause button gives you the ability to play or to pause the current track with a single press. Holding the Play/Power button for 2 seconds will turn the unit On if currently Off or Off if currently powered On. The unit will beep to indicate when power is turned Off. Note: a. The unit will stay on indefinitely as long as a Bluetooth device is actively paired to the MUDBTRC. b. The unit will turn Off after 5 minutes when there is no active Bluetooth device connection.
© 2014 Mitek Corporation. All rights reserved. MTX is a trademark of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 4545 East Baseline Rd. Phoenix, AZ 85042 U.S.A. 1-800-225-5689 MTX005074 RevA 12/14 • 21A10198 • AW0014782 4 MTX.
MUD65P CAGE MOUNT SPEAKER OWNER’S MANUAL MTX.
PRODUCT INFORMATION Model # Serial # Dealer’s Name Date of Purchase IN THE BOX • Speaker and Enclosure • Brackets • For mounting the bracket base to the enclosure • (8) M6-1.0x14mm stainless steel Hex Bolt • Ï- ÏmATÏWASHERÏSTAINLESSÏSTEEL • Ï- ÏSPLITÏLOCKÏWASHERÏSTAINLESSÏSTEEL • For tightening the bracket strap to the base • (2) M6-1.0x50mm stainless steel Hex Bolt • Ï- ÏSERRATEDÏmANGEÏLOCKÏNUTÏSTAINLESSÏSTEEL INTRODUCTION Thank you for purchasing this MTX Audio cage mount speaker pod.
INSTALLATION Ï #HOOSEÏAPPROPRIATEÏBRACKETÏCLAMP Ï 1b2", 13b4" or 2", for the application. Ï ! Ï TTACHÏBRACKETÏBASEÏTOÏENCLOSUREÏATÏDESIREDÏANGLEÏUSINGÏAÏMINIMUMÏOFÏTWOÏ ÏM6-1.0x14mm Hex BOLTSÏANDÏ- ÏLOCKÏWASHERS Ï)FÏONLYÏTWOÏ ÏBOLTSÏAREÏUSED ÏENSUREÏTHEREÏISÏAÏBOLTÏONÏEACHÏSIDEÏOFÏ the round base for secure mounting. Ï 3LIDEÏBRACKETÏCLAMPÏOVERÏPIPEÏORÏBARÏATÏDESIREDÏMOUNTINGÏLOCATION Ï ( Ï OLDÏTHEÏENCLOSUREÏINÏPLACEÏWHEREÏTHEÏBASEÏlTSÏINÏTHEÏOPENÏSECTIONÏOFÏTHEÏCLAMP Ï4HENÏPLACEÏTHEÏ M6-1.
The bracket base can rotate in any direction desired, a minimum of 2 bolts must be used, 1 on each side. © 2015 Mitek Corporation. All rights reserved. MTX is a trademark of Mitek Corporation. Designed and Engineered in the U.S.A. $UEÏTOÏCONTINUALÏPRODUCTÏDEVELOPMENT ÏALLÏSPECIlCATIONSÏAREÏSUBJECTÏTOÏCHANGEÏWITHOUTÏNOTICE Ï MTX Audio, 4545 East Baseline Rd. Phoenix, AZ 85042 U.S.A. 1-800-225-5689 MTX005257 RevA 7/15 •21A10428 • AW0015151 4 MTX.