Manualshelf

Owner's Manual

ManualsBrandsMTX ManualsCar Audio & VideoAmplified ThunderForms
12345678910
Table Of Contents
MTX.COM
5
!MPLIlED4HUNDER&ORM
Note: When routing power wire we recommend a connection directly to the battery.
Step 4 - Remove driver side threshold trim. Pull up on trim, it will remove easily.
Step 5 - Remove driver side kick panel, grasp center upper edge and pull outward allowing retaining
tab to unsnap.
Step 6 - Using furnished wiring harness route 10ga red power wire starting at pre-amp location.
Route wire under rear seat on driver side, over to threshold and under carpet to the front of vehicle.
Step 7 - Open hood.
Step 8 - $RILLÏAÏHOLEÏTHROUGHÏTHEÏlREWALLÏ,OCATEÏAÏSPOTÏLOWÏONÏTHEÏlREWALLÏONÏTHEÏDRIVERÏSIDEÏ9OUÏ
SHOULDÏALWAYSÏLOOKÏTOÏlNDÏAÏCLEARÏPATHÏ$RILLÏAÏHOLEÏFROMÏINSIDEÏOFÏTHEÏVEHICLEÏINTOÏENGINEÏCOMPARTMENTÏ
and insert grommet. Note: To avoid any damage to parts inside engine compartment, drill from inside
of vehicle using a short bit.
Step 9 - Route 10ga red power wire through grommet into the engine compartment.
Step 10 - Route 10ga red power wire through engine compartment safely away from any moving or
hot parts that could damage the wire.
Step 11 - Cut 10ga red power wire to length, connect the supplied fuse holder from the wire kit to the
end of the wire.
Firewall
Drill Hole for
Grommet
Battery