READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING HUNTING LOCATION: The enclosure mounts under the rear seat, firing up, in Ford Super Cab Trucks, TOOLS REQUIRED FOR INSTALLATION: Powered Screwdriver #2 Phillips Head Bit Wire Cutters 5/16” Wrench 8" Bit Holder Extension INSTALLATION: Follow the steps below 1. Slide front seats to full forward position and fold up rear seats. This will give you more room to work with. 2. Remove jack tools from floor and set them aside {you wilt reinstall them later in Step 23).
7. Open hood, Dit Hope. for Grommet Firewall Battery Ne 8. Drill a hole through the fire wall. Locate a spot low on the fire wall on the pas. singer side. You should always look to find a clear path. Drill a hole from inside of the vehicle into engine compartment and insert grommet. You may also find a per-existing, unused rubber grommet in this location that you can pass the wire through, Note: To avoid any damage to parts inside engine compartment, drill from inside of vehicle using a short bit. 9.
Ignition OFF When Disconnecting Battery Always turn the ignition OFF when connecting or disconnecting battery cables. Failing to do so may damage electronic components. 13. Ground amplifier fo chassis of vehicle; connect the terminal provided to the 10ga black wire from furnished wiring shames. A goad ground is as important as the power connection. The ground should be as short as possible and the contact point should be free of paint and debris.
16, Plug power wire harness into amplifier per-amp. 17. Replace amp fuse under hood. 18. When amp tums on, LED will display red during diagnostic mode, and then green, signaling amp is on and functioning. Amp will only tum on when radio ie on. 18. Adjust gain and crossover. Setting Gain Turn gain knob on Thunder form per-amp fo minimum, counter clockwise, Play a favorite tape or compact disc that contains consistent music and bass.
20. Reinstall threshold trim. Locate and align holes in vehicle with pins on trim; and snap back into place. 21. Place the drivers side of enclosure in first, so it fits into the seat bracket, Then side the passenger side, so the enclosure is tight against the seat bottom. 22; Using the supplied hardware; secure the enclosure to floor of vehicle as shown below. 24. Slide jack tools into center compartment under enclosure.
Conventional Wiring of Aftermarket Radio 20 Amp Fuse H-H + Bp Optional EB {Electronic Bass Control) .
en Warranty Statement — eer Thunderstorm Loaded Enclosures purchased in the United States from an authorized MTX dealer are guaranteed against defects in material and workmanship for a period of to years from the date purchased by the and user, and limited to the original retail purchaser of the product.