Owner's Manual

J-WRANGLER-07 Installation Guide

Jeep Wrangler 4 Door JK Series (Drivers Side) 2007 - UP

,OADED!MPLIlED

STEP 1: STEP 2:

Locate the rooftop mounting bolts as shown (driver side,

behind the rear seat above the wheel well). Note: Enclosure

DOESÏNOTÏlTÏCONVERTIBLEÏVERSION

Attach the mounting bracket to the enclosure as shown

using the supplied hardware.

STEP 3:

STEP 5:

When the bracket is assembled to the enclosure, this is

how the bracket mounts to the vehicle.

This is for reference only!

Your installation is complete. Enjoy your new bass in a small

space.

STEP 4:

-AKEÏALLÏlNALÏWIREÏCONNECTIONSÏ3EEÏ0AGEÏÏANDÏMOUNTÏ

the enclosure into place using the bolts removed from the

rooftop mounting location in Step 1.

PAGE 1
J-WRANGLER-07 Installation Guide Jeep Wrangler 4 Door JK Series (Drivers Side) 2007 - UP ,OADED !MPLIlED STEP 1: STEP 2: Locate the rooftop mounting bolts as shown (driver side, behind the rear seat above the wheel well). Note: Enclosure DOESÏNOTÏlTÏCONVERTIBLEÏVERSION Attach the mounting bracket to the enclosure as shown using the supplied hardware. STEP 4: STEP 3: When the bracket is assembled to the enclosure, this is how the bracket mounts to the vehicle.
PAGE 2
J-WRANGLER-07 Installation Guide Jeep Wrangler 4 Door JK Series (Drivers Side) 2007 - UP ,OADED !MPLIlED Speaker Level Wiring 20 Amp Fuse Source Unit without RCA Outputs _ + Red Power Wire Optional EBC (Electronic Bass Control) Right Channel* (+) GAIN STATUS RIGHT LEFT Right Channel* (-) X-OVER EBC REM GND 20A PWR INPUT Left Channel* (-) Left Channel* (+) Black Ground Wire * • Check with your vehicle manufacturer to determine • wire color for appropriate connection.