*%%0 '2!.
%!$ !,, $)2%#4)/.3 #!2%&5,,9 "%&/2% "%')..).' -/5.4).' ,/#!4)/. 4HE ENCLOSURE MOUNTS FIRING TO THE CENTER OF THE VEHICLE BEHIND THE FACTORY SPARE TIRE OF *EEP 'RAND #HEROKEE EXCEPT OPTIONAL ALUMINUM SPARE THAT WAS MOST PREDOMINANT IN MODEL YEARS 4//,3 2%15)2%$ &/2 ).34!,,!4)/. 7IRE #UTTERS 4ERMINAL #RIMPERS 0HILLIPS (EAD 3CREWDRIVER v .UT $RIVER ).34!,,!4)/.
2OUTE GA RED POWER WIRE FROM FURNISHED WIRING HARNESS STARTING AT PRE AMP LOCATION 2OUTE WIRE UNDER REAR SEAT ON DRIVERgS SIDE OVER TO THRESHOLD AND UNDER CARPET TO THE FRONT OF VEHICLE /PEN HOOD $RILL A HOLE THROUGH THE FIRE WALL ,OCATE A SPOT LOW ON THE FIRE WALL ON THE DRIVER S SIDE 9OU SHOULD ALWAYS LOOK TO FIND A CLEAR PATH $RILL A HOLE FROM INSIDE OF THE VEHICLE INTO ENGINE COMPARTMENT AND INSERT GROMMET &IREWALL $RILL (OLE FOR 'ROMMET "ATTERY .
2EMOVE AMP FUSE FROM -48 FUSE HOLDER #ONNECT FURNISHED RING TERMINAL TO POSITIVE SIDE OF BATTERY 2EMOVE BOLT FROM FACTORY BATTERY TERMINAL 0ASS BOLT THROUGH FACTORY BATTERY TERMINAL THEN RING TERMINAL AND INTO THE OTHER SIDE OF FACTORY BATTERY TERMINAL AND RETIGHTEN BOLT 'ROUND AMPLIFIER TO CHASSIS OF VEHICLE CONNECT THE TERMINAL PROVIDED TO THE GA BLACK WIRE FROM FURNISHED WIRING HARNESS ! GOOD GROUND IS AS IMPORTANT AS THE POWER CONNECTION 4HE GROUND SHOULD BE AS SHORT AS POSSIBL
!MP &USE ? /PTIONAL %"# %LECTRONIC "ASS #ONTROL 3/,)$ GAIN X-OVER LEFT "LUE 0INK STATUS RIGHT PWR EBC GND REM 20A "LUE 7HITE INPUT 342)0%$ "ROWN ,IGHT "LUE "ROWN 9ELLOW 3/,)$ 0LUG POWER HARNESS INTO AMPLIFIER PRE AMP 2EPLACE AMP FUSE UNDER HOOD 7HEN AMP TURNS ON ,%$ WILL DISPLAY RED DURING DIAGNOSTIC MODE AND THEN GREEN SIGNALING AMP IS ON AND FUNCTIONING !MP WILL ONLY TURN ON WHEN RADIO IS ON !D
/PTIONAL 4HE %"# OR %LECTRONIC "ASS #ONTROL ALLOWS A REMOTE BASS CONTROL TO BE ADJUSTED FROM THE DRIVERgS SEAT 3ETTING #ROSSOVER 9OU SHOULD SET THE CROSSOVER TO YOUR OWN PERSONAL LISTENING TASTE 4HE CROSSOVER IS ADJUSTABLE TO ANY FREQUENCY BETWEEN (Z COUNTERCLOCK WISE TO (Z CLOCKWISE !S A GUIDELINE THE GOAL IS TO CREATE THE ILLU SION OF BASS UP FRONT 4HE HIGHER THE CROSSOVER POINT THE MORE hAUDIBLY VISIBLEv YOUR SUB IS GOING TO BE 4AKE YOUR TIME AND REALLY LISTEN TO YOUR SYSTEM GRAB A SODA AND
)NSTALL GRILL PEGS PROVIDED INTO HOLES IN THE BACK OF THE GRILL 3TART PEGS INTO THE HOLES USING A v NUT DRIVER OVER PEG AND PUSH UNTIL BASE OF PEG IS FLUSH WITH THE GRILL BACK 0USH GRILL ONTO ENCLOSURE LINING UP THE HOLES ON THE ENCLOSURE WITH THE PEGS AND FIRMLY PUSHING INTO PLACE &OR TECHNICAL ASSISTANCE CALL #!,, -48 4HESE INSTRUCTIONS ARE GUIDELINES ONLY AND IN NO WAY ARE INTENDED TO REPLACE A PROFESSIONAL INSTALLATION !S ALWAYS BEFORE SCREWING OR DRILLING CHECK TO MAKE SURE YOU WILL
7ARRANTY 3TATEMENT 4HUNDER&ORM ,OADED %NCLOSURES PURCHASED IN THE 5NITED 3TATES FROM AN AUTHORIZED -48 DEALER ARE GUARANTEED AGAINST DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF TWO YEARS FROM THE DATE PURCHASED BY THE END USER AND LIMITED TO THE ORIGINAL RETAIL PURCHASER OF THE PRODUCT !MPLIFIED 4HUNDER&ORM %NCLOSURES PURCHASED IN THE 5NITED 3TATES FROM AN AUTHORIZED -48 DEALER ARE GUARANTEED AGAINST DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE YEAR FROM THE DATE PURCHASED BY THE END USE
Mitek Mobile Limited Warranty Our Guarantee Mitek Mobile products (including MTX, Streetwires, Coustic and Magnum) purchased in the USA after 1/1/2013 from an authorized Mitek retailer are guaranteed to be free from material defects in products and workmanship for five (5) years to the original end user purchaser, subject to the terms and conditions below.
No Other Warranties THE LIMITED WARRANTIES DESCRIBED ABOVE ARE EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED. MITEK DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING WITHOUT LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
