rt1:•J•:Jt•i REMOTE BASS KNOB INCLUDED JH5001 MONO-BLOCK CLASS DPOWER AMPLIFIER ·. . · J·1 .l~ .1111 J I • ' I I. i .·,,,..,.
JACKt-lAIVlrv1 P41- ■ J _, ,_, 8.97" (228mm) 7.61 " (193mm) 2.57" (65mm) (€ • == IINDESIGNED AND ENGINEERED MONROE, WI U.S.A. MADE IN CHINA & WARNING: This product can expose you to chemicals such as Styrene, which is known to the State of California to cause cancer, and N-Dimethylacetamide, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov © 2019 Mitek Corp. All rights reserved.
SPECIFICATIONS NEW CTA 2006-C ESPECIFICACIONES NUEVO CTA 2006-C ESPECIFICACOES NOVO CTA 2006-C CARACTERISTIOUES NOUVEAU CTA 2006-C 1-Channel Mono Block Class-D Power Amplifier Primary Ratings Primary Power Output Rating: 200Wat4O, 20-165Hz and :S 1% THD+N SNR Rating: 72dBA Secondary Ratings Dynamic Power Rating: 225W at 40, :S 1% TH D+N 375W at 20, s 1% TH D+N 550W at 10, s 1% THD+N Frequency Response: 20Hz to 250Hz Maximum Input Signal: 10V Minimum Input Signal: 135mV Crossover: Low Pass Filter 12dB/oc
JACKHAMMER SERIES AMPLIFIER OWNER’S MANUAL Use your smartphone to scan or visit youtube.com/user/MTXAudioUSA to learn how to properly install this amplifier. MTX.
PRODUCT INFORMATION Model # Serial # Dealer’s Name Date of Purchase INTRODUCTION Thank you for purchasing this MTX Audio Hi-Performance amplifier. Proper installation matched with MTX speakers and subwoofers provide superior sound and performance for endless hours of enjoyment whether you are waking the neighbors or just out enjoying your tunes.
CONTROL FUNCTIONS 1. Speakers - Connect speakers/subwoofers to these terminals. Be sure to check wire for proper polarity. Never connect the speaker cables to the chassis ground. 2. +BATT (+12 Volt Power) - Connect this terminal through a FUSE or CIRCUIT BREAKER to the positive terminal of the vehicle battery or the positive terminal of an isolated audio system battery.
PANEL LAYOUT JH3004 4-Channel Amplifier Panel Layout 5 FRONT REAR L CH L CH R CH R CH LINE INPUT JH3004 AUTO INPUT TURN ON MODE INPUT LEVEL EBC REM AUDIO 12 4CH 2CH 13 PRE IN SPK IN 14 15 + L CH – GND REM + R CH – +12V FRONT POWER INPUT SPEAKER OUTPUT REAR + L CH – 4 4 3 2 6 10 BRIDGE 1 11 6 MTX.
PANEL LAYOUT JH7005 5-Channel Amplifier Panel Layout 5 FRONT REAR L CH FRONT L CH REAR L CH L CH L CH L CH JH7005 JH7005 AUTO INPUT TURN ON MODE AUTO INPUT TURN ON MODE REM AUDIO REM AUDIO 5CH 4CH 5CH 4CH INPUT MODE INPUT MODE INPUT LEVEL INPUT LEVEL 4CH 2CH 4CH 2CH 12 PRE IN SPK IN PRE IN SPK IN 13 GND GND REM REM SUB SUB EBC EBC R CH R CH R CH R CH LINE INPUT R CH R CH LINE INPUT 14 15 + L CH – + L CH – +12V +12V + R CH – + R CH – SUB + SUB + FRONT FRONT POWER INPUT POWER INPUT SPE
PANEL LAYOUT JH5001 / JH10001 / JH15001 Mono Block Amplifier Panel Layout 5 JH15001 L CH AUTO TURN ON INPUT LEVEL EBC R CH REM AUDIO PRE IN SPK IN 12 GND REM LINE INPUT 14 15 +12V 1Ω MINIMUM POWER INPUT SPEAKER OUTPUT + 4 3 2 6 6 + – 1 7 8 9 MTX.
WIRING DIAGRAM See page 28 for amplifier wiring diagrams. INSTALLATION AND MOUNTING MTX recommends your new JACKHAMMER amplifier be installed by a 12 volt installation specialist. Any deviation from specified installation instructions can cause serious damage to the amplifier, speakers and/or vehicle’s electrical system. Damage caused from improper installation is NOT covered under warranty. Please verify all connections prior to system turn on. 1. Disconnect the vehicle’s negative battery cable. 2.
INSTALLATION For proper perfomance and safety, MTX recommends installing an inline fuse per the owner’s manual instructions according to the following.
SPECIFICATIONS Model Description JH15001 JH10001 JH5001 JH7005 JH3004 Mono Block Class-D Mono Block Class-D Mono Block Class-D Class-AB + Class-D Class-AB Primary Ratings Primary Power SNR Rating 600W at 4Ω, 20-90Hz and ≤ 1% THD+N 400W at 4Ω, 20-150Hz and ≤ 1% THD+N 200W at 4Ω, 20-165Hz and ≤ 1% THD+N 60W x 4 from 20-20kHz and 250W x 1 from 20-150Hz at 4Ω and ≤ 1% THD+N 60W x 4 at 4Ω, 20-20kHz and ≤ 1% THD+N 70dBA 68dBA 72dBA 60dBA 63dBA Secondary Ratings 60W x 4 at 4Ω, ≤ 1% THD+N (F
WIRING DIAGRAM Mono Block Amplifier Wiring (Single Subwoofer Load) FUSE 12V 1 Ohm Minimum Remote Signal Source Unit RCA Signal JH15001 L CH AUTO TURN ON INPUT LEVEL EBC R CH REM AUDIO 28 PRE IN SPK IN MTX.
WIRING DIAGRAM Mono Block Amplifier Wiring (Multi-Subwoofer Load) FUSE 12V Remote Signal 2 Ohm Minimum Source Unit 2 Ohm Minimum RCA Signal JH15001 L CH AUTO TURN ON INPUT LEVEL EBC R CH REM AUDIO PRE IN SPK IN LINE INPUT NOTE: Equivalent parallel woofer load cannot be less than the minimum load rating. These are monoblock amplifiers, not multi-channel amplifiers. The minimum load for the JH15001, JH10001 and JH5001 amplifier is 1Ω. The minimum load for the Sub Channel JH7005 amplifier is 2Ω.
WIRING DIAGRAM JH3004 Amplifier Wiring (4-Channel Mode) Crossover Crossover FUSE Remote Signal 12V Crossover Crossover Source Unit RCA Signal RCA Signal FRONT REAR L CH L CH R CH R CH LINE INPUT JH3004 AUTO INPUT TURN ON MODE INPUT LEVEL EBC REM AUDIO 30 4CH 2CH PRE IN SPK IN MTX.
WIRING DIAGRAM JH3004 Amplifier Wiring (3-Channel Mode) Crossover Crossover FUSE Remote Signal 12V Source Unit 4-Ohm to 8-Ohm RCA Signal RCA Signal FRONT REAR L CH L CH R CH R CH LINE INPUT JH3004 AUTO INPUT TURN ON MODE INPUT LEVEL EBC REM AUDIO 4CH 2CH PRE IN SPK IN MTX.
WIRING DIAGRAM JH7005 Amplifier Wiring (5-Channel Mode) Crossover 2-Ohm to 4-Ohm Crossover FUSE Remote Signal 12V Crossover Source Unit RCA Signal RCA Signal FRONT REAR SUB L CH L CH L CH R CH R CH R CH LINE INPUT JH7005 AUTO INPUT TURN ON MODE INPUT MODE INPUT LEVEL EBC REM AUDIO 32 5CH 4CH 4CH 2CH PRE IN SPK IN MTX.
NOTES: MTX.
NOTES: 34 MTX.
WARRANTY INFORMATION Mitek Mobile products (including MTX, Streetwires, Coustic and Magnum) purchased in the USA after 1/1/2015 from an authorized Mitek retailer are guaranteed to be free from material defects in products and workmanship for two (2) years to the original end user purchaser, subject to the terms and conditions below.
© 2019 Mitek Corporation. All rights reserved. MTX is a trademark of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 4545 East Baseline Rd. Phoenix, AZ 85042 U.S.A. N535 MTX005827 RevC 2/19 • 21A10712 • AW0015727 MTX.
