READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING MOUNTING LOCATION: The enclosure mounts behind rear seat firing down,in Jeep Wranglers. TOOLS REQUIRED FOR INSTALLATION: Powered Screwdriver Right Angle Skew driver 8" Bit Holder Extension Wire Ties 10mm Wrench Hostility Knife Phillips Screw Driver INSTALLATION: Follow the steps below 1. Flip rear seat to full forward position, This will give you moral room to work with. 2.
5. Locate the factory wire harness running under the drivers’ side threshold. 6. Use a Phillips screw driver fo remove the three clips holding the factory wire harness under the door threshold on the drivers’ side. 7. Make a small cut in the carpet located just under the per-amp location of the enclosure. This will allow you to hide the wires under the floor mat. 8. Using the furnished wiring harness, route the 10ga red power wire starting at per-amp location.
12. Route 10ga power wire through engine compartment safely away from aay moving or hot parts that could damage the wire. 13. Cut 10ga red power wire {o length, connect the supplied fuse holder from the wire kit to the ond of the wire 14. Remove amp fuse from MTX fuse holder. Connect furnished ring terminal to positive side of battery. Remove 10mm nut from factory battery terminal. Place ring terminal on battery post and re tighten nut.
20 Amp Fuse “Tj som 50C Satori Taco Carter) [! 19. Replace amp fuse under hood. 20. When amp tums on, LED will display red during diagnostic mode, and then green, signaling amp is on and functioning. Amp will only turn on when radio is on. 21. Adjust gain and crossover, Setting Gain Tum gain knob on Thunder Form per-amp to minimum, counter clockwise. Play a favorite tape or compact disc that contains consistent music and bass. Tum the source unit to maximum listening level.
be adjusted from the drivers’ seat, Setting Crossover You should set the crossover fa your own personal listening taste. The cross. over is adjustable to any frequency between 50H2 {counterclockwise} to 150Hz {clockwise). As a guideline, the goal is fo create the Illusion of bass up front. The Higher the Crossover Hoist the more “fallibly visible” your sub is gong 16 be. Take your time and really listen to your system, grab a soda and a few of your favorite tunes and have fun.
protect your eyes. Always provide ventilation.
Warranty Statement —— money Rutherfordium Loaded Enclosures purchased in the United States from an authorized MTX dealer are guaranteed against defects in material and workmanship for a pariah of two years farm the date purchased by the end user, and limited to the original retail purchaser of the product, Amplified Rutherford Enclosures purchased in the United States trim an authorized MTX dealer are guaranteed against defects in malted and workmanship for a period of one year from the date purchased by th
