+ VOL MUTE VOL – SOURCE + + VOL MUTE VOL VOL – SOURCE MUTE VOL – SOURCE OWNER’S MANUAL MUD6SPBT UNIVERSAL BLUETOOTH SOUND BAR Near Field Communication MTX.
IMPORTANT NOTICE If you have any questions regarding wire routing in a vehicle, please contact MTX Technical Support at 1-800-225-5689. When connecting power and ground wires ensure that the red power wire is fused at the point where it is connected to the vehicle’s battery. Failure to do so can result in damage to the vehicle if a short circuit develops between the vehicle connection point and the product.
ELECTRICAL OPERATION 1. Tap the Power button to turn the unit on. (Power, Ground, and ACC wire need to be connected to a 12V power source.) 2. Tap the Power button to switch modes between Bluetooth and AUX. 3. Hold the Power button for 2 seconds to turn the unit Off. Note: The buttons will stay illuminated as long as the ACC wire has 12V applied to it. 4. The included fuse loop, ring terminals, and butt connector allow for easy wire connection to a 12V power source.
INSTALLATION The MUD6SPBT can be used with any 12-volt battery and can be mounted to a variety of bars using the included hardware. The unit has three wires in its wiring pigtail. The red wire, hot, should be directly connected to the vehicles positive battery terminal, the black wire, ground, should be connected directly to the vehicle’s chassis where paint has been removed or the negative terminal on the battery, and the blue wire, accessory, should be connected to the ignition wire on the vehicle.
NOTES: MTX.
NOTES: 6 MTX.
NOTES: MTX.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
