Owner`s manual

TROUBLESHOOTING
Problem Cause
Solution
No + 12V at Remote Connection
Supply+ 12V to Terminal
No + 12V at Power Connection
No LED Indication
Supply+
12V to Terminal
Insufficient Ground Connection
Verify Ground Connection
Blown Power Fuse
Replace Fuse
Volume on Source Unit Off
Increase Volume on Source Unit
Speaker Connections Not Made
Make Speaker Connections
Power
LED On,
Gain Control on Amplifier Off
Turn Up Gain
No Output
Signal Processing Units Off
Apply Power to Signal Processor
All Speakers Blown Replace Speakers
Head Unit Volume Set Too High
Lower Head Unit Volume
Output Distorted
Amplifier
Gain Set Too High
Lower Amplifier Gain
Balance Reversed
Speaker Wire L & R Reversed
Correct Speaker Wire Orientation
RCA Inputs Reversed
Reverse RCA Inputs
Bass is Weak
Speakers Wired Out of Phase
Wire Speakers with Correct Phase
Not Using MTX Subwoofers Buy MTX Subwoofers
Excessive Output Levels
Lower the Volume
Blowing Fuses
Amplifier Defective
Return for Service
WIRING DIAGRAM
See page 26 for amplifier wiring diagrams.
MTX.COM