TN8MS 8" TERMINATOR MICRO SUBWOOFER ENCLOSURE OWNER’S MANUAL MTX.
IMPORTANT NOTICE If you have any questions regarding wire routing in a vehicle, please contact MTX Technical Support at 1-800-225-5689. When connecting power and ground wires ensure that the red power wire is fused at the point where it is connected to the vehicle’s battery. Failure to do so can result in damage to the vehicle if a short circuit develops between the vehicle connection point and the product.
CONTROL FUNCTIONS 1. Power Terminal (+12V) - This is the main power input for the amplifier and must be connected directly to the positive terminal of the vehicle’s battery for proper operation. Use caution when installing (+12V) power cable in the vehicle. Avoid running this cable parallel with RCA cables, antennas, or other sensitive equipment due to massive currents that can induce noise into the audio system. It is also very important to have a tight, secure connection for maximum performance.
INSTALLATION MTX recommends your new TN8MS powered enclosure to be installed by an Authorized MTX retailer. Any deviation from specified installation instructions can cause serious damage to the amplifier, subwoofer and/or vehicle’s electrical system. Damage caused from improper installation is NOT covered under warranty. Please verify all connections prior to turning on your system! 1. Disconnect the vehicle’s negative battery cable. 2. Determine the mounting place for your MTX TN8MS.
NOTES: 14 MTX.
NOTES: MTX.
© 2019 Mitek Corporation. All rights reserved. MTX is a trademark of Mitek Corporation. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice. MTX Audio, 4545 East Baseline Rd. Phoenix, AZ 85042 U.S.A. 1-800-225-5689 MTX005821 RevB 2/19 • 21A10714 • AW0015732 MTX.
