Instruction manual

Precautions before starting work(Continued)
DANGER
䋣
If the machine falls over while working, the machine will move forward due to the kicking
motion of the foot while it is lying on its side. If the ground is solid, it will move quickly and is
very dangerous. To ensure that the operator and anyone nearby are safe, turn the throttle
lever to the engine stop position and make sure the machine stops. You must be extremely
careful when working on a road because a serious accident can easily occur.
Before lifting the machine, make sure that there is no damage to any of the components on
the machine (look especially for damage to the rubber dampers and the hook). There must
not be any loose or missing screws and the machine must generally be in a safe condition.
Turn the engine off before lifting the machine.
Use wire cables with enough strength to support the machine.
DO NOT lift it higher than necessary, for safety.
DO NOTuse a damaged wire cable.
Never lift or lower the machine rapidly when using a hydraulic shovel or a crane.
When lifting the machine, do not allow any people or animals to pass under or near the
machine.
When using any type of equipment to lift the machine, be careful that the lifting equipment
does not cause an accident. Make sure you check the lifting equipment carefully, to ensure
that there are no problems or damage.
Take the utmost care not to allow the
machine to fall during work, or when
stopped or stored. Secure the
machine with a rope or similar tie
when stored or left idle so that it
cannot fall. If the rammer falls over
when children are around, a serious
accident may occur. If the machine
foot is worn, the machine will be
especially unstable. If the machine
foot is worn badly, replace it with a
new one.
Only use the single hook to lift the
machine. DO NOT support it from any
other points (such as the handle).
■
■
■
■
■
■
■
■
■
■
■
Precautions while lifting
DANGER
䋣
4