Installation Instructions

ROAD TH
UNDER SOUND BAR PLUS BY MTX, SATIN BLACK 2720
866 277 9598 | [e-mail]
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
ELECTRICAL OPERATION
STEP 1
Tap the Power button to turn the unit on. (Power, Ground, and Ignition
wire need to be connected to a 12V power source.)
STEP 2
Tap the Power button to switch modes between Bluetooth and AUX.
STEP 3
Hold the Power button for 2 seconds to turn the unit O󰀨.
STEP 4
The integrated fuse and ring terminals allow for easy wire connection to
a 12V power source.
STEP 5
The remote turn on (blue wire) only operates when the unit is powered
on.
Note: The indicator light will illuminate Blue when in Bluetooth mode
and Green when in AUX mode.
OPERATION
FOLLOW THESE STEPS TO UTILIZE THE BLUETOOTH FUNCTIONALITY USING A
BLUETOOTH ENABLED DEVICE:
STEP 1
Power the unit On by tapping the Power button once.
STEP 2
Select Bluetooth by tapping the Power button until it blinks Blue.
STEP 3
Select “MTX Sound Bar” from the menu on your Bluetooth enabled
device. The unit will power on in Bluetooth mode rst when it is turned
on by tapping. If the Ignition wire is disconnected, (vehicle is turned o󰀨
and then turned on) the unit will revert back to the previous Bluetooth or
AUX setting.
STEP 4
Choose “Pair” when prompted.
STEP 5
Once “Paired” the unit will be able to play audio from your Bluetooth
device.
The front panel control buttons will control track forward/back and
volume up/down in this mode. The Play/Pause button will mute the
output and the LED indicator will blink Blue when in Mute mode.
FOLLOW THESE STEPS TO UTILIZE BLUETOOTH IN A NFC
(
NEAR FIELD
COMMUNICATION
)
ENABLED DEVICE:
STEP 1
Power the unit On by tapping the Power button once.
STEP 2
Select Bluetooth by tapping the Power button until it blinks Blue.
STEP 3
Tap the NFC enabled device on the (left) side of the enclosure (marked
by NFC label).
STEP 4
Choose “Pair” when prompted.
STEP 5
Once “Paired” the unit will be able to play audio from your NFC device.
FOLLOW THESE STEPS TO UTILIZE AN AUXILIARY INPUT DEVICE:
STEP 1
Power the unit On by tapping the Power button once.
STEP 2
Select Auxiliary by tapping the Power button until it blinks Green.
STEP 3
Connect an audio device to the AUX input using the “Green” 3.5mm
input on the side of the unit. The LED will illuminate Green, and will blink
Green when in mute mode.
The front panel control buttons will adjust the Volume up/down in this
mode. The Play/Pause button will mute the audio output and the LED
indicator will blink Green when in Mute mode.
-CONTINUED-
PPAGE 4
302720
DPF-MRK-003 REV D 03/12/20