Installation Instructions
3
Pumper
Cap
Installation:
1.
Confirm
the
hydrant
is
de-pressurized
as
described
in
steps
1-4 on
page 2.
2.
Use
Hydrant
Wrench
to
remove
existing
Pumper
Cap.
3.
Install
Inner
Pumper
Cap
with
plastic
plug
and
tighten.
4.
Place Sealed
Electronics.
Note
Sky
should
be
pointing
towards
the
sky and as
parallel as possible
to
the ground. Also
note the
location of the
NFC antenna shown by the
words NFC and arrow.
5.
Place outer
cap
and
tighten
with
washer and
nut.
Outer Pumper
Cap can
be rotated
in 60 degrees
increments.
6.
After the Pumper Cap and electronics have been installed, the
phone app can be used to checked reception. App will use existing
cellular modem and network to determine cellular reception in the area.