Use and Care Manual

ManualsBrandsMUELLER ManualsAppliances30 lb. UltraSonic Nugget Portable Countertop Ice Maker in Stainless Steel

Close the Front Lid. Press the “ON/OFF” key and the ___ indicator will

illuminate with a solid light, indicating that the ice-making process has

begun.

The ice-making cycle will last approximately 20-30 minutes, depending

on the ambient temperature and water temperature. As water is pumped into

the unit, ice will be produced and will automatically fall from the Ice Tray

directly into the Ice Basket.

NOTE: During initial use, it may take some time for the Ice Maker to regu-

late. Initial ice produced may be slightly irregular in form.

The indicator will light up when the Ice Basket is full and then the Ice

Maker will stop the ice-making cycle automatically. You can open the Front

lid of the Ice Maker at any time to monitor progress or remove ice. Gently

remove the ice from the Ice Basket with the Ice Scoop or take out the Ice

Basket to pour ice into a separate container for use or freeze as desired.

Refill the Water Reservoir.

NOTE: If the ice is not removed it will start to melt over time. The meltwa-

ter will return to the Water Reservoir.

Once ice is removed and the Ice Basket has been reinserted and lid

closed, the ice-making function will restart automatically. If the ice is not

removed, the Ice Maker will automatically restart after approximately 8

hours. Alternatively, you can press the “ON/OFF” key to restart the appliance

at any time.

While the Ice Maker is on, you can manually check the water level periodi-

cally by lifting out the Ice Basket. Alternatively, if the water pump cannot

inject water, the Ice Maker will stop automatically. The indicator will flash

when the Water Reservoir needs to be refilled.

• If the appliance is connected to an external water source via a ¼ PE tube

as shown in the section “WATER SUPPLY”, it will be refilled with water

automatically and the Ice Maker will restart the ice-making cycle; alter-

natively, the user can remove the Ice Basket and manually refill the water

reservoir to the MAX level. The Ice Maker will restart the ice-making cycle.

NOTE: Make sure the Front Lid is closed after manually refilling water to

avoid overflow.

• If the appliance is not connected with an external water source, firstly

remove the Ice Basket, and then fill the Water Reservoir with water manu-

ally. After the Water Reservoir is refilled with water, reinsert the Ice Basket

reinsert the Ice Basket, close the Front Lid, and then the Ice Maker will

restart the ice-making cycle automatically.

When you have your desired amount of ice, you can stop the ice-making

cycle at any time by pressing the “ON/OFF” key and unplugging the unit from

the wall outlet. Transfer ice to a freezer.

The unit can remain turned ON for extended periods of time. Ice will con-

tinue to be produced up until the Ice Basket is full. Over time, the ice will start

to melt, the meltwater will return to the Water Reservoir, and the unit will con-

tinue to restart the ice-making cycle until it is manually turned off. Turn off

when not in use.

NOTE: We recommend draining water regularly and adding fresh water to

ensure optimal hygiene levels.

NOTE: Certain noises are normal when operating this Ice Maker, including a

bubbling, gurgling, or knocking sound when refrigerant is circulating through

the pipes, or a clinking sound when ice cubes are dropped into the basket.

To keep your ice tasting fresh and your UltraSonic Nugget Ice Maker working

at its best, we recommend cleaning your Ice Maker before first use and

further at least once per week.

Take out the Ice Basket and Ice Scoop and hand wash only in warm water

with mild detergent. Rinse and wipe dry. Do not use any solvents or

chemicals.

Wipe the interior of the Ice Maker with a soft cloth soaked in warm water

and white vinegar. Repeat with a clean damp cloth.

Pour in fresh, room temperature water into the Water Reservoir. Do not fill

above the MAX line. Add a couple of drops of mild detergent to the water.

Caution: Do not use organic solvent, harsh chemicals, boiled water, strong

acid, and strong alkali products for cleaning, unless otherwise specified.

Press and hold the “Clean” key for approximately 3 seconds. The indi-

cator lights up and the appliance will start the self-cleaning function

where the water solution will circulate through the system.

After cleaning for 8 minutes, the appliance will stop working and the __

indicator will flash.

Unplug the unit from the power outlet. At the rear of the unit, detach the

Drain Plug from the back of the Ice Maker and position the two Drain

Tubes down over a nearby sink or catchment container. Remove the Drain

Plug from the end of the Drain Tubes and drain until the Water Reservoir

inside the appliance is empty.

Reattach the Drain Plug to the Drain Tubes. Attach the Drain Plug back

into the two slots at the back of the Ice Maker as illustrated in the “HOW

TO USE” instructions earlier in this manual.

If the unit has been moved in this process, wait for 30 minutes for the unit

refrigerant to settle. Repeat steps 3-7, this time using fresh, room tem-

perature water only, to rinse the Water Reservoir and internal mecha-

nisms.

In the interior of the Water Reservoir, pull off the Water Filter from the

water outlet. Separate the two parts and use a small brush to clean any

mineral build-up on the mesh filter. Rinse under water. Replace the Water

Filter.

WHEN TO DRAIN

We recommend full draining your Ice Maker when:

Storing or anytime the unit is being relocated.

You turn it off for more than a few days. (i.e. vacation)

You are not using much ice. Continuous recirculation of meltwater may affect

taste.

See “CLEANING AND MAINTENANCE” instructions, Step 6 for information on

how to drain water out of the unit.