Use and Care Manual

6
BEFORE FIRST USE
4
3
2
1
IMPORTANT: ENSURE THE ICE MAKER IS KEPT IN AN UPRIGHT POSI-
TION AT ALL TIMES.
The incline angle of the Ice Maker unit should not exceed 45° during
transportation or use. Do not turn the Ice Maker upside down. Doing so
could cause the compressor or refrigerating system to operate incor-
rectly.
Remove packaging materials and dispose of appropriately by keeping
out of reach of children.
Find a location for your Ice Maker that is protected from direct sunlight
and other sources of heat (i.e.: stove, furnace, radiator) or corrosive
gases. Ensure the surface is dry, level, stable and able to support the
total weight when the unit is full of water.
IMPORTANT: The Ice Maker is not designed to be installed in an outside
area such as a garage or porch or in areas of extreme temperatures.
Allow sufficient ventilation around the appliance. Leave a clearance of at
least 3 inches on all sides of the Ice Maker for proper ventilation.
Please allow time for the fluids in the compressor to settle after the Ice
Maker is moved or transported. Always allow the unit to come to room
temperature.
IMPORTANT: AFTER THE UNIT HAS BEEN POSITIONED AND LEVELED,
PLEASE WAIT FOR AT LEAST 2 HOURS BEFORE PLUGGING IN THE ICE
MAKER FOR THE FIRST TIME. Note, if the unit has only been slightly
moved, (e.g., moved forward for draining purposes), then wait for 30
minutes before re-plugging in.)
Prior to first use, clean the appliance and accessories in accordance
with the “CLEANING AND MAINTENANCE” instructions provided later in
this manual.
Do not consume the first few cycles of ice during initial use, including
after cleaning.
5
6
7
AMBIENT TEMPERATURES OF BELOW 41°F OR ABOVE 90°F WILL
HINDER THE PERFORMANCE OF THE APPLIANCE.