Instructions / Assembly

Press the top half of the connector into the bottom half until it clicks into place and is

secure. This will pierce the low voltage wire and connect the light to the transformer.

Test the connection by plugging in the transformer to see if the light turns on. If it does,

unplug the transformer and continue the installation. If it does not, unplug the trans-

former and check the connection between the transformer and low voltage wire, re-in-

stall the connector, and ensure power is available to the outlet you are using.

Once the connection is secure repeat the process for the remaining lights.

Once all lights are connected it is recommended to wrap each connector with electrical

tape for additional protection.

Note: If you want to install this with your existing low voltage lighting system skip step 4

and instead plug the lights into your existing 18AWG to 12AWG SPT-2W wiring.

APP Download

Search and download “MULANDI Smart” in Apple APP store (iOS)

or the Android APP store.