Warranty

3. Using the App
1) After logging in, click “Me”, and then click “Home Management”, the “Home Management” page will be displayed.
2) Click “My Home” to add rooms. Click “Save” in the upper right corner to complete the room settings.
After first setting, you can also click the button on the “My Home” page to change your room settings at any time.
* Before adding devices, make sure
you enable your smart device's
“Bluetooth” and your new Mulandi
Smart Lights are plugged in.
1) Click “add device” from the HOME
page (Figure 1) if your BLUETOOTH
detects your new lights they will pop up
as in (Figure 2), then choose “Go To
Add”. This will automatically add your
new lights to the system.
2) The system will go to devices add
page and then click the “+” in red frame
(Figure 3). If you successfully added
your devices you can SKIP step 3. If the
devices didn't add automatically,
proceed to Step 3.
3) If you try the 2 steps above and the
devices are not added automatically
move closer to the lights and try again.
If you continue to have troubles with
automatically adding the devices you
can add them manually. To add them
Manually - Click “add device” from the
HOME page (Figure 1) and on the next
page (Figure 2) choose “ Do Not Add”.
On the Add Manually page click on
“Lighting Source (BLE)” (Figure 4).
Unplug your lights and wait 5 seconds
and plug them in. The lights should
flash to indicate that they are in pairing
mode. Choose “Confirm The Light Has
Flashed”, click “ Next” (Figure 5) to find
devices. Once all devices are found,
add devices with ”Add All” or click “+” in
red frame (Figure 5). When all devices
are added click “Done” (Figure 6).
3.1 Home/Member Management
3.2 Adding Devices - all devices
Figure 3 Figure 4
Figure 1 Figure 2
4