Morningstar PS-30 Manual

Operation
ProStar Operator’s Manual
49
48
4.0
Lighting Control Mode (DIP 1 ON)
• A quick press and release of the push-button will
clear any faults or reminders that are present. A
second quick press will then conduct a five minute
lighting test. If no faults or reminders are present,
the initial press will conduct the lighting test. A
lighting test is used to verify correct wiring in
the load circuit, and/or verify that the lighting
components are operational.
• If the unit is set to manual Equalization (EQ), and no
faults or reminders are active, press and hold the
push-button for 5 seconds to initiate an EQ.
Reset ProStar to Factory Settings
To restore factory settings: disconnect PV; disconnect
battery power; press and hold down the push-button;
re-start the ProStar by connecting the battery; keep
the push-button depressed for 10 secs. A Custom
Settings Edit fault will occur - see p. 65 in Section 5 for
details. The unit will then need to be re-powered to
resume normal opertation.
4.5 Custom Settings
4.5.1 Programming with the Meter Display
The ProStar is available in metered and non-metered
versions. The metered model allows:
• Custom programming, including lighting programs,
directly from the unit.
• Extensive settings adjustment and information as
shown partially in Figure 4-6 below.
Figure 4-6. Simplified Meter Map.
Start Lighting Test
Load Disconnect
Factory Reset
Reset Control
Backlight Timer
Backlight
Target Voltage
Battery Temp.
Display Screens and Programming
Models:
PS-30M
PS-15M
Main Screens
Daily Charging Stage - Time
Daily Charge Transferred -
Battery and Load
Solar Current - Battery
Current - Load Current
Daily Max / Min
Battery Voltages
STATUS
HISTORY
See Complete History
Screens Online, or in
Manual Insert
SYSTEM
DISPLAY
SETTINGS
COMMANDS
Faults
Load / Light State
Charge State
Input Voltage
Alarms
CUSTOM PROGRAMMING:
To
Programming
Screens
Clear KWh
Records
Graphs
Error Log
Battery Sense
Hour Meter
Last Equalization
Brightness
Auto Scroll
Contrast
Auto Return
Auto Scroll Timer
Language
Temp. Units
See Complete
Programming Screens
Online or in Manual Insert
See Complete
Programming Screens
Online or in Manual Insert
Clear Resettable Ah
Clear Total Ah
Serial No.
Firmware Version
Battery Type
Absorption Voltage
Float Voltage
EQ Voltage
Input Mode
System Voltage