Morningstar PS-30 Manual

ProStar Operator’s Manual
67
7.0
Warranty and Policies66
WARRANTY CLAIM PROCEDURE
1. Before proceeding, please refer to product manual,
including the Troubleshooting section.
2. Contacting your authorized Morningstar distributor or
dealer from whom you purchased the unit is
the first step in the warranty process. Local dealers can
often address warranty issues quickly.
3. If supplier is unable to address the issue, please contact
Morningstar by e-mail
([e-mail]) with:
(A) purchase location - business or company name
(B) full model and serial numbers (SN is 8-digits on
unit bar label)
(C) failure behavior, including LED indications
(D) array configuration, panel Pmax, Voc, Vmp, Isc,
and nominal battery voltage; these specifications
are needed to receive assistance.
(E) multi-meter available (for field troubleshooting)
4. After warranty replacement has been approved and new
unit(s) received, please return failed unit(s) using pre-paid
shipping label, and follow any product specific instructions
if requested by Morningstar Warranty Dept.
5. If instructed by Morningstar, after warranty replacement
shipment has been received, return of failed unit(s) is
required before further warranty replacements can be
considered for the original or future cases.
NOTE: Please do not return units without an RMA or
case number. Doing so will increase the time required to
resolve your claim.
PS-15 PS-30
PS-15M PS-30M
Electrical:
Nominal Battery voltage 12 or 24 Volts
Battery voltage Range 10-35 Volts
Voltage accuracy
0.1% +/- 50mV (all)
Max. Battery Current 15 Amps 30 Amps
Max. PV open-circuit voltage 60 Volts
Load Current Rating 15 Amps 30 Amps
Self Consumption <22mA (no meter) <40mA (meter)
LED Indications (1) status, (3) battery SOC
Transient Surge Protection 1500 watts (solar, battery, load)
Mechanical:
Dimensions: 6.01(W) x 4.14(L) x 2.17(D) in.
153(W) x105(L) x 55(D) mm
Weight: 13.8 oz. (no meter)
15.1 oz. (meter)
Wire Size Range:
Power Terminals 2.5 - 16 mm
2
/ #14 - 6 AWG
Maximum Torque 35 in-lb
Battery/Temp. Sense 0.25 - 1.0 mm
2
/ #24 - 16 AWG
Enclosure IP20, Type 1
Battery Charging:
4-Stage Charging: Bulk, Absorption, Float, Equalize
Temperature compensation
Coefficient: -30mV / ºC / 12 Volt
Temperature compensated
set-points: Absorption, Float, Equalize, HVD
7.0 TECHNICAL SPECIFICATIONS