Owner`s manual

Now that you have installed the faucet, connected to the plumbing, and prepared the hous-

ing, you are ready to complete the installation of your Drinking Water System.

Reference Section II for installing the faucet.

Reference Section III for connecting to the plumbing.

Reference Section IV.A for installing the filter.

Reference Section IV.B for connecting housing Inlet and Outlet adapters.

Straight Adapter Connection:

1. Connect the blue faucet tubing to the Small Straight Adapter (#3) that you previously

connected to the OUTLET port.

2. Using wire cutters or knife, cut (square cut) the tip end off of the blue plastic tube con-

nected to the faucet. Do not use scissors.

3. The tubing must be fully inserted in the adapter / switch. It is recommended that you

measure and mark the end of the tubing that you are inserting in the adapter to assure

that it is inserted as far as it will go. The 1/4” blue tubing should be inserted about 5/8”.

4. Push the tubing through the small hole in the adapter until you feel resistance; at this

point, the tubing is not fully inserted. Then push firmly until the tubing is inserted as far

as it will go (see Item 3 above for measurements).

5. Pull to check that the tubing is secure.

Housing Top

Insert tubing and push until

you feel resistance -- at this

point, the tubing is not fully

inserted. Push firmly until the

tubing is inserted as far as it

will go.

V. Tubing Connections

Note: Use wire cutters or sharp knife to cut tubing. Do not use scissors.

V.A Connecting the Blue Faucet Tubing to Outlet Port

blue tubing

OUTLET

Adapter

OUTLET

INLET