Owner`s manual

Mounting the Faucet
1. Note that the blue tubing is attached to the faucet. Before mounting the faucet on your sink:
a. Carefully remove the plastic packing tube from the hole in the faucet body (CAUTION: do not remove the faucet
handle (operating lever).
b. With the operating lever in the "up" position, insert the spout: First wet the o-ring area of the spout, under hot water,
and insert spout in the hole in the faucet base from which packing tube was removed.
Once the spout is connected, the faucet handle can be released.
2. From the sink top, place the black (soft) rubber washer and then the white plastic cover plate
over the faucet hole. The white plastic cover plate is visible from above the sink.
3. Feed the blue faucet tubing through the hole.
4. From under the sink, slide over the blue tubing:
a. the black plastic (hard) washer (with the small side up)
b. the steel washer
c. lock washer
d. the nut
5. Hand tighten the nut to secure the faucet. Using vice grips, secure the nut and faucet below
the sink.
6. From above the sink, (CAUTION: protect the faucet base from scratching) using an
8" adjustable wrench, turn the faucet base clockwise until firm. Then remove the vise grips
from below the sink.
To operate your Multi-Pure Faucet, just push down on the handle, or for continuous flow, lift up the handle. To stop
flow, return the handle to its original position.
The faucet is now ready to be connected to your drinking water unit See Section V.A.
II.B Installing the Stainless Steel Faucet
Tip
MC208
Spout
MC552
Handle
MC245
Body with
stud
Steel washer
MC301
Lock Washer
MC301
Blue Tubing
Plastic Washer
MC301
Nut
MC301
Cover Plate
MC301
Rubber Washer
MC301
COUNTERTOP
Complete Faucet Assembly
with Blue Tubing
MC550WTW
(standard faucet tip, handle and
cover plate are white; faucet
accessories also are available
in black)
7