SDS

Page 2 of 6
5. FIREFIGHTING MEASURES
5.1 Extinguishing media: N/A - Non-flammable
5.2 Special hazards arising from the substance or mixture: No data available
5.3 Advice for firefighters: Wear self-contained breathing apparatus for firefighting if necessary.
5.4 Further information: No data available
6. ACCIDENTAL RELEASE MEASURES
6.1 Personal precautions, protective equipment and emergency procedures.
Use personal protective equipment. Avoid breathing vapors, mist or gas. Ensure adequate ventilation. See
section 8 for recommendations on the use of personal protection equipment.
6.2 Environmental precautions
Non-hazardous to the environment.
6.3 Methods and materials for containment and cleaning up.
Soak up with inert absorbent material and dispose in a suitable container. Clean surfaces thoroughly with
water. Dispose of waste and cleanup materials in accordance with regional/local regulations.
7. HANDLING AND STORAGE
7.1 Precautions for safe handling
Avoid contact with skin and eyes. Avoid inhalation of vapors or mist. For precautions see section 2.2
7.2 Conditions for safe storage, including and incompatibilities
Store in a cool, dry and well ventilated area. Keep away from incompatible materials (see section 10 for
incompatibilities).
7.3 Specific end use(s)
Apart from the use listed in section 1.2 no other specific uses are recommended.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 Control Parameters: (Propylene glycol)
Components with workplace control parameters
Component
CAS-No
Value
Control parameters
Basis
Propylene glycol*
57-55-6
TWA
10mg/m
3
USA. Workplace Environmental
Exposure Levels (WEEL)
*<50% of mixture. Remaining components not at reportable concentrations
8.2 Exposure controls
Appropriate engineering control
Handle in accordance with good industrial hygiene and safety practices. Wash hands after contact and at
the end of the workday.
Personal protective equipment
Eye/face protection – Protect from splashing; wear safety glasses when handling.
Inhalation – Non-volatile at standard temperatures and pressures. Standard ventilation is
expected to be adequate.
Skin – Handle material to avoid skin contact. Wash contacted areas with water as required to
avoid skin irritation.