Network Card User's Manual

ISI Quick Start Guide
5
Software Installation
Introduction
The ISI Card ships with software/drivers for each of the following operating systems:
Windows
®
2008, Vista, XP, 2003, 2000 Server, and 2000 Advanced Server, and
Linux. You may need to configure the modems for your country/region, the procedure
for doing this is at the end of this Guide.
For additional Windows Operating System Software Installation Procedures, refer to
the User Guide.
Installing a device driver modifies your system. For this reason, only the super user
(system administrator) is allowed to perform the installation. If you cannot login as
administrator, find the person in your organization with this authorization (i.e.,
password). To begin driver installation, login as administrator.
Driver Installation for Windows Server 2008 and Vista
The following driver installation procedure is based on Windows Server 2008 64-bit
Operating System. The procedure may vary slightly for the Windows Server 2008 32-
bit Operating System
Card Driver Installation
1. Power up your computer.
2. Windows Server 2008 will detect the ISI Card. A screen from the tray area, at
the bottom right of the screen will appear briefly Installing Device Driver
Software.
3. The Found New Hardware screen appears for Windows to install driver
software for your PCI Serial Port.
Click on Locate and install driver software (recommended). Windows
will guide you through the process of installing driver software for your
device.