User Guide Data/Fax Modems MT2834BA/MT2834BL

30
Chapter 5 - Command Mode
Multi-Tech Systems, Inc. MT2834BA/BL Series User Guide
STORE MODEM &F Load Factory Defaults
CONFIGURATIONS &W Store Configuration & S-Register
AND DEFAULTS Parameters
Z Reset Modem
V Result Code Terse/Verbose
$SP UNIX/"Spoofing”
&M Synchronous/Asynchronous Mode Select
&X Synchronous Transmit Clock Select
CONFIGURE Q Result Codes Enable/Disable Response
COMMAND &Q Result Code Selection
RESPONSES E Echo Command Characters
V Result Code Terse/Verbose
X Result Code...Basic/Extended/Call Progress
CONDITION &G Guard Tones
PHONE LINE M Monitor Phone Line
&T Remote Digital Loop Signal
#T Enable/Disable Trellis Coded Modulation
B Bell/V.21 Tones
#F Fallback When On-Line
&CD Cleardown at Disconnect (2834 Series only)
#A Auto-Speed Detect
CONTROL RS232C &C Carrier Detect Control
INTERFACE &D Data Terminal Ready Control
&R Clear To Send Control
&S Data Set Ready Control
&RF CTS/RTS Control
&SF DSR/CD Control
CONFIGURE &E0 Normal Mode
ERROR &E1 Auto-Reliable Mode
CORRECTION &E2 Reliable Mode
#L0 Negotiate V.42 Mode During Handshake
#L1 MNP On/LAPM Off
#L2 LAPM On/MNP Off
#L3 Direct LAPM/Phase Out Handshake
$A Auto-Reliable Buffering
$F Enable/Disable Auto-Reliable Fallback Character
$R Retransmit Count
$E Error Correction at 300 bps
CONFIGURE &E3 Flow Control Disabled
FLOW CONTROL &E4 Hardware Flow Control
&E5 Xon/Xoff Modem-Initiated
&E6 Xon/Xoff Modem Responds/No Pass-Through
&E7 Xon/Xoff Modem Responds/Pass-Through Allowed
#X Send Single/Multiple Xoff Characters
&E8 Enq/Ack Off
&E9 Enq/Ack On
&E10 Normal Mode Modem Flow Control Off
&E11 Normal Mode Modem Flow Control On
&E12 Computer-Initiated/Off
&E13 Computer-Initiated/On
&BS Maximum Block Size
$EB 10/11 bit Asynchronous Format
#P Parity Selection