User's Manual

Chapter 3 – Fax Class 2 Commands
Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C) 63
Data Reception
Class 2.1 +FDR
Syntax: +FDR<CR>
The +FDR command initiates transition to Phase C data reception. This can occur
after answering, after dialing, after a document is received, or after a page is
received.
The modem may report the negotiated T.30 parameters with the remote ID and NSS
frame information, if available. When the modem is ready to commence data transfer,
it will issue a CONNECT response code. After the host receives the CONNECT
response and the host is ready to accept data, it will issue a <DC2> character (12h)
to the modem.
Class 2 +FDR
Same as Class 2.1.
Session Termination
Class 2.1 +FKS
Syntax: +FKS
The +FKS command causes the modem to terminate the session in an orderly
manner by sending a DCN message at the next opportunity and hanging up. At the
end of the termination process, the modem will report the +FHS response with a
result code, go on-hook, and set +FCLASS=0.
This operation can also be invoked by using the <CAN> (cancel) character during
Phase C data reception.
Class 2 +FK
Syntax: +FK
Essentially the same as Class 2.1.
Initialize Facsimile Parameters
Class 2.1 +FIP
Syntax: +FIP
The +FIP command causes the modem to initialize all Service Class 2.0/2.1 facsimile
parameters to the default settings. This command does not change the setting of
+FCLASS. It has the same effect as if the host had issued individual parameter
setting commands.
MultiModem modems do not support multiple profiles, and thus do not support the
optional +FIP=<value> syntax documented in T.32.
Class 2 There is no equivalent command in Class 2.