User's Manual

Chapter 3 – Fax Class 2 Commands
Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C) 69
T.30 Phase D Post Page Responses
Post Page Message
Class 2.1 +FET:
Syntax: +FET:<ppm>
The +FET:<post page message> response is generated by a receiving facsimile
modem at the end of Phase C reception on receipt of the post-page message from
the transmitting station. The +FET:<ppm> response is generated in execution of a
+FDR command. The <ppm> codes correspond to the T.30 post page messages as
described in Table 3.1.
Table 3.2 Class 2.1 Post Page Message Codes
PPM code T.30 mnemonic Description
0 MPS Another page next, same document
1 EOM Another document next
2 EOP No more pages or documents
Class 2 +FET:
Syntax: +FET:<ppm
The Class 2 response is similar to the Class 2.1 response, except for the different
<ppm> codes described in Table 3.1.
Table 3.3. Class 2 Post Page Message Codes
PPM code T.30 mnemonic Description
0 MPS Another page next, same document
1 EOM Another document next
2 EOP No more pages or documents
3 PPS-NULL Another partial page next
4 PRI-MPS Another page, procedure interrupt
5 PRI-EOM Another document, procedure interrupt
6 PRI-EOP All done, procedure interrupt
Call Termination with Status
Class 2.1 +FHS:
Syntax: +FHS:<hangup status code>
+FHS: indicates that the call has been terminated. The hang-up cause is reported,
and stored in the +FHS parameter for later inspection. The <hsc> values are
hexadecimal codes as described in Table 3.4.
+FHS:<hsc> is a possible intermediate result code to any host action command
described in Action Commands section. It is always followed by the OK result code.
Class 2 +FHNG:
Syntax: +FHNG:<hangup status code>