Manual

66
Chapter 7 - Using the MultiVOIP Software
Multi-Tech Systems, Inc. MultiVOIP User Guide
Manual Upgrade Procedure
Follow this procedure only if you want to manually upgrade your MultiVOIP.
Note: Steps 4-8 may be performed via the command port or over IP.
1. Run MultiVOIP Configuration from your old version of the MultiVOIP software. Note the
current settings. Your MultiVOIP will be reset to factory defaults during this upgrade.
2. Unistall your old version of MultiVOIP software by selecting the Unistall MultiVOIP
Configuration option from the program group.
3. Install the H.323 compatible software from the MultiVOIP CD.
4. a. From the program group of the MultiVOIP software, select Download Firmware.
b. Enter “*.upg” in the File name box and press ENTER.
c. Select the file named boot_100.upg, if you are using the command port.
OR
Select tftp.upg if you are using IP.
5. From the program group of the MultiVOIP software, select Download Factory Defaults.
6. From the program group of the MultiVOIP software, select Download Firmware. Select
the file named mtvoip.bin.
7. From the program group of the MultiVOIP software, select Download Voice Coders.
Select the default file.
8. From the program group of the MultiVOIP software, select Download H323 Stack.
Select the default file.
9. Select MultiVOIP Configuration from the program group and reconfigure your MultiVOIP.
The upgrade is complete.