User Guide

Chapter 3 – Configure and Manage Using a Web Browser
RouteFinder RF500S User Guide 36
– WAN Filter Settings
The WAN Filter Settings function allows the network administrator to define whether
remote/outside users have the permission to access the local network. To activate, check
the
WAN Side Filter Enabled box. Then define the policy.
1. To access this screen, click the
Filter Settings button on the left side of the
Advanced Settings screen. Then click the WAN Filter Settings button on the left
side of the screen. The
WAN Filter Settings screen displays.
2. Check the
WAN Side Filter Enabled box to begin a list of users and permissions.
3. Select the WAN side filter:
Block or Pass.
4. Select the client filter settings:
Block or Pass.
5. Select the protocol to be used from the
Protocol drop-down list box.
6. Enter the client
IP Address Range and Destination Port Range.
7. Click the
Add button. The entry displays on the lower part of the screen.
8. Continue adding table entries. When complete, click the
Submit button.