user manual

Part 3 – AT Commands Wi-Fi Devices Chapter 13 – WLAN AT Commands for the SocketWireless Wi-Fi
Universal IP AT Commands Reference Guide (Document S000457K) 69
#WLANUSEPROFILE – User Profile
Description: Sets and displays the use profile value. If user profile value is set to any value between 1 and 4,
then at the time of user name association, the module first scans for the selected user profile
parameters.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANUSEPROFILE=<value>
AT#WLANUSEPROFILE? Read or display the current setting.
Values: 1 – 4
#WLANGETRSSI – Received Signal Strength
Description: This command displays the current received signal strength.
Syntax: AT#WLANGETRSSI
Values: The response returns a signal strength value from -256 dBm through -1 dBm.
Note: A value of 0 equals no connection to an access point.
Example: AT#WLANGETRSSI
RSSI : 0
OK
#WLANACTIVATE – Move Module out of Power Save
Description: This command moves the module out of Power Save during an active connection. See
#WLANDOZE
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANACTIVATE
Values: NA
#WLANROAM – Enable/Disable Roaming
Description: This command enables/disables automatic roaming of the module when the wireless connection
is lost by the Access Point.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANROAM
Values: 0 - Disable Auto Roam
1 - Enable Auto Roam
Default: 1
#WEP64KEY – Keys for WEP64 Security Mode
Description: Sets keys for WEP64 Security mode.
Note: The module must be reset to put the command into effect.
Syntax: AT#WEP64KEYn ="<value>"
AT#NWEP64KEYn? Read or display the current setting.
Values: ASCII text string of 10 hexadecimal characters. Valid characters include 0-9, a-f or A-F
Default: 6162636465