+ FOR PROFILUX plus Quick Start Guide.
EN Quick Start Guide FOR PROFILUX plus Lamp Head Socket I / Charger connection Lamp Head Socket II Handle Battery Level Indicator Fuse Holder Power On-Off 2
+ PROPAC Important Information! 1. Read the Multiblitz Profilux Plus „Quick Start Guide“ thoroughly before operating a Propac battery pack together with a Profilux Plus unit. 2. Only Profilux Plus units are to be operated on a Propac battery back. 3. A 150 W halogen tube (Code: PACHAL) is included in the scope of supply. To ensure a correct rendition of color for the modeling light, we highly recommend using this halogen tube in your Profilux Plus unit when it is being operated on a Propac battery pack.
EN Quick Start Guide FOR PROFILUX plus PROPAC FAQ Is there an external hot swappable battery available for the Propac? No, we think that much capacity does not need an extra battery. Can I operate my Profilux Plus unit(s) on a Propac while charging? No, the lamp sockets are being switched off during charging. Can I operate other flash units than a Profilux Plus on my Propac? DO NOT, you will damage the other flash unit and the Propac.
+ PROPAC Technical Data PROPAC 1 2 2 2 PROPAC 1 LAMP SOCKETS (splash proof) for Profilux Plus units Obtainable performances with 1 Profilux Plus unit max. Ws 200 / 400 / 600 max.
EN Quick Start Guide FOR PROFILUX plus Connection of lamp cable and multi-voltage charger. 2 1) Align plug and socket, see arrows. 2) Connect plug to socket. 3) Turn plug right until it snaps in. 1 1 3 Additional visual indications on a Profilux Plus unit when operated with a Propac. 15 sec auto-off” mode The modeling-Llght on-off button/100% on-off button will blink when the unit switches to “auto-off” mode after not being fired for 15 sec.
+ PROPAC Charging the Propac 1) Low Battery: Switch off and disconnect your Profilux Plus unit(s) in order to charge the battery pack.* *A soon as the red LED of the battery level indicator starts blinking, the Propac should be turned off and recharged promptly. Otherwise, the Profilux Plus unit(s) will cut-out automatically (deep discharge protection). 2) Re-charging the battery pack: Switch off your Propac and connect the multi-voltage charger.
D Quick Start Guide FOR PROFILUX plus Lampenanschluss I / Ladebuchse Lampenanschluss II Tragegriff LadestatusAnzeige Sicherung An-Aus Schalter 8
+ PROPAC Wichtige hinweise! 1. L esen sie unbedingt den Punkt „Wichtige Hinweise“ im Multiblitz „Profilux Plus Quick Start Guide“ sorgfältig durch, bevor sie ein Propac Akku zusammen mit einem Profilux Plus Gerät betreiben. - D as Display am Profilux Plus wechselt zwischen der Anzeige der eingestellten Blende und der Anzeige „LO“ (für „Low“). Die letzte der vier vorhandenen grünen LEDs am Propac blinkt und ein akustisches Signal ertönt. 2.
D Quick Start Guide FOR PROFILUX plus PROPAC FAQ Ist eine separate Schnellwechselbatterie für das Propac erhältlich? Nein, wir glauben dass bei so viel Kapazität keine extra Batterie nötig ist. Kann ich mein(e) Profilux Plus Gerät(e) an meinem Propac betreiben während dieser lädt? Nein, während des Ladevorgangs werden die Lampenanschlüsse abgeschaltet.
+ PROPAC Technische Daten PROPAC 1 2 2 2 PROPAC 1 Anschlüsse für Profilux Plus Geräte (spritzwassergeschützt) Mögliche Leistungen mit 1 PROFILUX Gerät max. Ws 200 / 400 / 600 max.
D Quick Start Guide FOR PROFILUX plus Anschluss des Lampenkabels und Multi-Voltage Ladegeräts 2 1) Stecker und Anschlussbuchse ausrichten, siehe weiße Pfeile. 2) Stecker mit Anschlussbuchse verbinden. 3) Stecker nach rechts drehen und zum Einrasten bringen. 1 1 3 Zusätzliche visuelle Anzeigen beim Betrieb eines Profilux Plus Geräts an einem Propac. 15 Sek.
+ PROPAC laden des Propac 1) Akku schwach: Schalten sie ihr Profilux Plus Gerät aus und trennen sie es vom Propac um den Propac wieder aufzuladen.* * Sobald die rote LED der Ladestatus-Anzeige am Propac zu blinken beginnt sollte das Propac ausgeschaltet und umgehend wieder aufgeladen werden. Andernfalls werden die angeschlossenen Profilux Plus Geräte automatisch abgeschaltet (Tiefentladungsschutz).
images by: stefan Ditner 14
+ Shooting Setup: Profilux Plus 600 // Reflector COMWEW // Propac 1 15
+ VISIT US online: www.multiblitz.de + SCOPE OF DELIVERY / LIEFERUMFANG packit 1 / packit 2 1x L AMP CABLE, 5 m Propac to Profilux Plus Code: PACNET 1x P ROPAC 2 Code: PAC 1 Code: PAC 2 1x HALOGEN TUBE 1x P YREX DOME 150 W / 100 - 130 V Code: PACHAL Code: PLUSKLA 1x M ulti-Voltage CHARGER 100 - 260 V Code: PACLA MULTIBLITZ Dr. Ing. D. A.