User`s manual

11.2 Remove the Unit

1. Frame

2. Insert ﬁngers into the groove in the front of frame

and pull out to remove the frame. (When reattaching

the frame, point the side with a groove downwards and

attach it.)

3. Insert the levers supplied with the unit into the

grooves at both sides of the unit as shown in ﬁgure until

they click. Pulling the levers makes possible to remove

the unit from the dashboard.

11.3 DIN Rear Mount (Method B)

Installation using the screw holes on

the sides of the unit.Fastening the

unit to the factory radio mounting

bracket:

1. Select a position where the screw

holes of the bracket and the screw

holes of the main unit become aligned

(are ﬁtted) and tighten the screws at 2

places on each side. Use either truss

screws (5x5 mm) or ﬂush surface screw

(4x5 mm).

2. Screw (“T” Position)

3. Dashboard or Console.

NOTE: The mounting box, outer trim

ring, and half-sleeve are not used for

method B installation.

11. Install the Unit