User guide

M349 Announcer version 01.02 revised 4 August 2005 page 5
Installation
Choosing A Suitable Site
The system should be installed on a level, solid surface, where:
♦ It is near an earthed mains socket outlet, so that the mains lead will reach. This socket shall
remain easily accessible.
♦ The telephone line cords will reach your telephone line sockets.
♦ There is a minimum of background noise, so that you can record your announcements satis-
factorily.
♦ You can easily see the display (preferably at head height).
♦ The unit is away from direct sunlight or heating appliances
♦ Air can circulate around the unit (allow at least 10 mm clearance all round)
♦ The temperature is maintained between -10°C and 40°C.
♦ The unit is away from water or corrosive chemicals, particularly salt spray.
Unpacking The System
When you unpack the system from its box, you will find:
♦ The Multimessage Model 349 announcer.
♦ A mains lead with fitted plug.
♦ 5 telephone line cords.
♦ A telephone handset.
♦ This User Guide.
Installation Procedure
Please make sure you follow these steps in the correct order, and that you have read the TECHNI-
CAL NOTES.
1 Carefully remove the unit from its plastic bag.
2 Plug the local handset in to the socket marked ‘LOCAL HANDSET’.
3You must plug the line cords into the M349 sockets , before connecting the other end to the
PSTN or PBX port.
4 Plug the mains lead into the socket at the rear of the unit.
5 With the switch on the mains socket set to off, plug the mains lead into the socket. Switch on
at the socket.
6 Switch the battery switch to the on position.