User guide

Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem rCell User Guide 47
is a number needed by the manual keying code. Enter any 3-digit hexadecimal number,
which is unique for a security association. It should be in the form 0xhex (0x100 through
0xfff is recommended). If you have more than one manual connection, then the SPI Base
must be different for each one.
Left Next Hop Next Hop is the address of the next device in a routing table’s path that moves a packet to
it’s destination. This setting can be configured or left as a static value: 0.0.0.0. When not
configured, the value is set to the Gateway of the Box/Gateway configured on the
Interface/Right IP. The selection is based on the Left and Right IP.
Local WAN IP Select the Interface to initiate the IPSec tunnel (Left Security Gateway).
Local LAN Select the internal subnet of the local security gateway for which the security services are
to be provided. If the RouteFinder acts as a host, this should be configured as None. Other
options are: Any, LAN, LAN Interface, WAN 1, WAN 1 Interface.
Remote Gateway IP Select the interface in which the IPSec tunnel ends. In the case of Road Warriors with a
Dynamic IP addresses, this should be configured as ANY. Other options include: LAN,
LAN Interface, WAN 1, WAN 1 Interface, and None.
FQDN FQDN is a DNS resolvable fully qualified domain name with which identity the right peer
can be identified. When FQDN is entered, the Remote Gateway IP should be blank.
Remote LAN This is the internal subnet of the remote security gateway for which the security services
are to be provided. If the remote end is a host, this should be configured as None.
NetBIOS Broadcast Check this option to enable broadcasts over the connection. It will allow computers on the
network to share Microsoft file and printer sharing information.
104B114BSave Button
Click the Save button to save these settings.