User guide

Chapter 3 – Using the Web Management Software
50 Multi-Tech Systems, Inc. MultiModem rCell User Guide
Serial Port > Server Settings
This feature enables a TCP/UDP client on the Ethernet network to connect to the remote serial terminal connected to the DE9,
RS232 port on the router. The router acts as a TCP/UDP server which allows two way traffic between the TCP/UDP client and
the remote terminal on the serial port.
The initial connection setup for the TCP/UDP server is as shown below.
116B TCP/UDP – Server Configuration
Configures TCP/UDP Server through which the serial terminal connected to the RS-232 connector, DE9 on the back of
the unit listens for the remote TCP/UDP client to communicate on the LAN/WAN.
106BStatus: Sets the client status to either Enable or Disable. The default is Disable
107BServer Type: Sets the client to either TCP or UDP. The default is TCP.
Port: Sets the server port. The default is None
Connection Terminate By: Sets the connection terminate sequence as follows:
Escape Sequence: Set the escape sequence characters at which the connection should terminate.
Inactivity timeout: Set the inactivity timeout at which the connection should terminate.
Others: The other terminating sequences are: DTR-toggle or Always-On.
DTR-toggle: If DTR status goes low, the connection terminates.
Always-On: Sets the terminate sequence as Always-on.
108B136BSubmit Button
Click the Submit button to save these settings.
Router hardware
TCP/UDP
Server
Serial
Device
DE9
Connector
LAN / WAN
TCP/UDP
Client
HyperTerminal /
Minicom