Cut Sheet
Armorlite® Type MC
Lightweight Aluminum Interlocked Armor. 600 Volts.
Copper Power Conductors. THHN/THWN Insulated Singles.
Green Insulated Grounding Conductor.
Sizes 14 AWG through 2 AWG. Rated VW-1.
APPLICATIONS
Southwire Armorlite
®
Type MC Cable is suitable for use as follows:
•
Branch, feeder and service power distribution in commercial, industrial, institutional, and multi-residential buildings.
•
Power, lighting, control, and signal circuits.
•
Fished or embedded in plaster.
•
Concealed or exposed installations.
•
Environmental air-handling spaces per NEC 300.22 (C).
•
Places of Assembly per NEC 518.4 and theaters per NEC 520.5.
•
Installation in cable tray and approved raceways.
•
Under raised floors for information technology equipment conductors and cables per NEC 645.5(D) & 645.5(D)(2).
•
Class I Div. 2, Class II Div 2, & Class III Div. 1 Hazardous Locations.
STANDARDS & REFERENCES
Southwire Armorlite
®
Type MC Cable meets or exceeds the requirements of the following
•
UL 83
•
UL 1569
•
UL 1685
•
Federal Specification A-A59544 (formerly J-C-30B)
•
FT4/IEEE 1202 (70,000 Btu/hr) Vertical Cable Tray Flame Test
•
NEC
•
Listed for use in UL 1, 2 and 3 Hour Through Penetration Firestop Systems
CONSTRUCTION
Southwire Armorlite
®
Type MC Cable is constructed with soft-drawn copper, Type THHN/THWN conductors rated 90°C dry
available in sizes 14 AWG through 2 AWG, and a green insulated grounding conductor. The conductors are cabled together
and a binder tape bearing the print legend is wrapped around the assembly. Aluminum interlocking armor is applied over the
assembly.
Tue Jan 18 05:19:42 EST 2011 Page 1 of 3