User manual

1
14
15
2
3
4
5
6
7
8
9
10
9
2. Overview MULTIGyro G3
3. Features
2.1 Overview LED display
“IN” area Model type selection (jumper)
1
Flight mode changeover switch
8
J1 – V-tail
2
Aileron
9
J2 – Delta wing or ying wing
3
Elevator
10
J3 – Standard aircraft model
4
Rudder
“OUT” area Gyro gain adjustment
5
Aileron
11
Potentiometer rudder
6
Elevator
12
Potentiometer elevator
7
Rudder
13
Potentiometer aileron
Supported model types:
Standard
aircraft
Aircraft with
a V-tail
Delta wing or
flying wing
4. Technical data
11
2
3 1
3
2
1 1
2 3
LED display
14
Red LED
15
Blue LED
Status LED display Description
Initialisation The blue and red LEDs ash rapidly for three
seconds after switching on the gyro.
Initialised. Do not move the aircraft until initialisation
has been completed!
Blue LED ashes after initialisation. Initialisation successful.
Red LED ashes rapidly after initialisation. Initialisation failed. Undened model type. Check the
adjustments J 1-2-3.
Operation Blue LED illuminated permanently. Standard mode. Ready for ight.
Red LED illuminated permanently. Heading hold mode. Ready for ight.
Both LEDs are off. Gyro is deactivated. Ready for ight.
· It is possible to toggle between three flight modes while
your model is airborne: 1. Off / 2. Standard / 3. Heading hold
· MULTIGyro G3 supports three model types:
1. Standard aircraft / 2. Delta wing or flying wing /
3. Aircraft with a V-tail
· Specially optimised for 3D flight.
· Independent gyro adjustment and gyro reversing for each
channel.
· Small and lightweight, thus also suitable for smaller aircraft.
1
Aileron servo
2
Elevator servo
3
Rudder servo
Voltage range 5 - 6V DC
PWM output 50Hz, or 20ms
PWM signal 1520±500µs
Full scale range 970~2070µs
Gyro sample rate 1KHz
Operating temperature -40°C to 85°C
Dimensions 47 x 33 x 14 mm
Weight 11 g
11
12
13
