Instruction Manual

Instruction Sheet

Subject: FreshBlender Water Filtration Retrofit

SCOPE: ALL MULTIPLEX FRESHBLENDER UNITS

1 of 3

 DocumentNumber:020007984 June06,2022

MULTIPLEX

645 PARK EAST BLVD SUITE 5, NEW ALBANY, IN 47150

800-689-0157OR844-724-CARE

WWW.MULTIPLEXBEVERAGE.COM

Refreshing the Experience

This water filtration kit bracket is only compatible with units

that have a drain shelf similar to picture below. This kit is

NOT compatible with units that have enclosed drain boxes.

TOOLS REQUIRED

• Puncture Resistant Gloves

• Clean Bucket

• Clean Towels

• Drill (cordless recommended)

• Universal Screw Driver

• Permanent Marker

• 3/32” Metal Drill Bit

• 3/8” Drive Socket or Wrench

PARTS REQUIRED

• 020007985 Water Filtration Kit

Warning

PowerOFFthemachineandunplugfrompowersource,

this unit contains sharp moving parts. Wear gloves to

protect hands.

Important

Keep refrigeration cabinet door closed so product

remains chilled while unit is off.

PREPARATION

1. Review literature packet included with parts and filters.

2. Power unit OFF using power switch on top right of unit

and unplug.

3. Installation of new water filtration kit will be on back

ofmachine.Withoutdamagingwaterordrainlines,

carefully move machine away from wall.

4. Place bucket under rear drain.

5. Turn off water shutoff valve and disconnect water line

from back of machine.

PAGE 1
MULTIPLEX 645 PARK EAST BLVD SUITE 5, NEW ALBANY, IN 47150 800-689-0157 OR 844-724-CARE WWW.MULTIPLEXBEVERAGE.COM Refreshing the Experience Instruction Sheet Subject: FreshBlender Water Filtration Retrofit SCOPE: ALL MULTIPLEX FRESHBLENDER UNITS This water filtration kit bracket is only compatible with units that have a drain shelf similar to picture below. This kit is NOT compatible with units that have enclosed drain boxes.
PAGE 2
Subject: FreshBlender Water Filtration Retrofit INSTALLATION 6. Carefully hang water filtration bracket on back of unit as shown below. 11. Tighten the four (4) nuts located behind the gauges with 3/8” Drive Socket. 12. Use permanent marker to write install date on each filter. 7. Position water filtration bracket so it does not extend past the side of the unit. Make sure water filtration gauges do not come in contact with the drain funnel. 13. Carefully insert the Pre-filter in the left assembly slot.
PAGE 3
Subject: FreshBlender Water Filtration Retrofit 17. Connect right water line of assembly to machine. REASSEMBLY 18. Move machine back in place. 19. Verify drain is connected correctly. 20. Plug unit to power source and power ON. VERIFY OPERATION 21. Enter the Service Menu. A. Menu screens are hidden and will require a password. From start screen, touch the three corners in the order shown to access the password screen. B. Enter password for SERVICE MENU and then press ENTER. 3 1 2 22.