User Manual

20
Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely
hope that you are completely satisfied with the contents of your kit. However, we would ask you to check all the parts
before you start construction, as we cannot exchange components which you have already worked on. If you
find any part is not acceptable for any reason, we will readily correct or exchange it. Just send the component to our
Model Department. Please be sure to include the purchase receipt and a brief description of the fault.
We are constantly working on improving our models, and for this reason we must reserve the right to change the kit
contents in terms of shape or dimensions of parts, technology, materials and fittings, without prior notification. Please
understand that we cannot entertain claims against us if the kit contents do not agree in every respect with the
instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating
them safely requires a certain level of technical competence and manual skill, together with discipline and
a responsible attitude at the flying field. Errors and carelessness in building and flying the model can result
in serious personal injury and damage to property. Since we, as manufacturers, have no control over the
construction, maintenance and operation of our products, we are obliged to take this opportunity to point out
these hazards and to emphasise your personal responsibility.
Additional items required for the FunMan:
Adhesive and activator:
Use medium-viscosity cyano glue (
not styrofoam cyano). It is important to use activator when using cyano. Epoxy
adhesives produce what initially appears to be a sound joint, but the bond is only superficial, and the hard resin breaks
away from the parts under load.
Hot-melt glues can also be used.
Important note
This model is not made of styrofoam™, and it is not possible to glue the material using white glue or epoxy.
Please be sure to use cyano-acrylate glue exclusively, preferably in conjunction with cyano activator (kicker).
We recommend medium-viscosity cyano. This is the procedure: spray cyano activator on one face of the
Elapor®; allow it to air-dry, then apply cyano adhesive to the other face. Join the parts, immediately position
them accurately, and wait a few seconds for the glue to harden.
Recommended equipment:
Zacki ELAPOR 20g VE1 OrderNo. 852727
LiBatt FX 3/1-950 (M6) OrderNo. 157321
Receiver RX-5 light M-LINK ID7 OrderNo. 55833
SMART SX M-LINK OrderNo. 1530/0/1
MULTIcharger L-703 EQU OrderNo. 82523
Optional equipment:
Receiver RX-6-DR light M-LINK 2,4 Ghs OrderNo. 55809
Receiver RX-7-DR light M-LINK 2,4 Ghz OrderNo. 55818
Aileron-upgrade set OrderNo. 65164
Li-Batt eco 3/1-2000 (M6) OrderNo. 157231
MULTIlight, 5 LED´s OrderNo. 73020
Floats OrderNo. 733069
Transmitter COCKPITSX OrderNo. 45130/1/2
Combo MULTIcharger LN-3008 EQU w.Mains PSU, AC/DC 230V/12V 5,0A OrderNo. 92545
Charge lead w. high current plug (M6) OrderNo. 92516
Please take care when handling cyano-acrylate adhesives. These materials harden in seconds, so don’t get
them on your fingers or other parts of the body. We strongly recommend the use of goggles to protect your
eyes. Keep the adhesive out of the reach of children.
Note: please remove the pictures from the center of the instructions!