Operation Manual

5.2 CONNECTING THE BATTERY

IMPORTANT: To avoid damage to the unit, never connect outputs together or in par-

allel!

Important!!! Before connecting a battery pack, make one last check that all the set para-

meters are correct! The battery may be damaged, explode or catch fire if the settings are

incorrect. To avoid a short-circuit with the banana plugs, always connect the charging leads

to the battery charger first and then to the battery. Follow the reverse procedure when dis-

connecting. Ensure correct polarity!

Equalizer connection:

The black wire of the voltage sensor lead from the battery must be connected to the charger

at the arrow marking. The arrow marking indicates the earth pole (negative). Ensure

correct polarity! See below!!

Note:

For safety reasons, when charging/discharging Lithium batteries, one should always

connect the battery voltage sensor lead to the charger!

Operating instructions

POWER PEAK® TRIPLE 360 W EQ-BID

This example only serves as a reference and is intended to demonstrate the connection

of the voltage sensor lead to the equalizer.

OLTAGE SENSOR

+S1

+S2

+S3

EQ-Adapter

Multiplex-PQ No.308213

EQ-Adapter Multiplex-

JSTXH No.308214

EQ-Adapter

Multiplex-TP/FP No.308215

6. AUTOMATIC MODE

When the "AUTO" button is pressed from the start display, the charger operates in auto-

matic mode, whereupon, all the parameters are set

automatically. "AUTOMATIC" is only available for

NC / NiMH battery types.

# 30 8562