user manual

MVC98D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (1/12/11) — PAGE 21
Inspection and Maintenance Service Tables.
To make sure your plate compactor is always in good working
condition before using, carry out the maintenance inspection in
accordance with Tables 5 through 7.
Daily Service
Check for leakage of fuel or oil.
Check for loose screws including tightness. See Table 7
below (tightening torque ), for retightening:
Remove soil and clean the bottom of compaction plate.
Check vibrating case for any oil leakage.
Check engine oil.
.7ELBAT
retemaiD)mc/gk.ni(EUQROTGNINETHGIT
lairetaM
mm6 mm8 mm01 mm21 mm41 mm61 mm81 mm02
T4 07 051 003 005 057 001,1 004,1 000,2
T8-6 001 052 005 008 003,1 000,2 007,2 008,3
T11 051 004 008 002,1 000,2 009,2 002,4 006,5
* 001
~003
053
~056
007
)munimulafositrap-retnuocesacnI(*
)dednahthgirllaeraenihcamsihthtiwesunisdaerhT(
.wercsdna,tlobhcaenodekramsilairetamfoytilauqdnalairetaM
2D89-CVM.5ELBATENIHCAM
NOITCEPSNI
METI
FOSRUOH
NOITAREPO
gnissiMroesooL
swercS
yreve(sruoh8yrevE
)yad
straPdegamaD
yreve(sruoh8yrevE
)yad
tleB-V
tnemecalpeR/kcehC
sruoh002yrevE
kcehChctulCsruoh002yrevE
kcehCliOrotarbiVsruoh001yrevE
liOrotarbiV
tnemecalpeR
sruoh003yrevE
kcehChctulCsruoh002yrevE
2D89-CVM.6ELBATKCEHCENIGNE
METINOITAREPOFOSRUOH
kaeLleuFroliO)yadyreve(sruoh8yrevE
gninetsaFfossenthgiT
sdaerhT
)yadyreve(sruoh8yrevE
dnakcehCliOenignE
tnemhsinelpeR
)yadyreve(sruoh8yrevE
mumixamdeificepsothsinelpeR(
)level
tnemecalpeRliOenignE
ot05yrevenehtsruoh52tsrifretfA
sruoh001
gninaelCretliFriAsruoh001yrevE
.ecnanetniamenignenosliatedroflaunamenigneetarapeseeS
MAINTENANCE
Inspection and other services should
always
be carried out
on hard and level ground with the engine shutdown.
CAUTION
These inspection intervals are for operation under normal
conditions. Adjust your inspection intervals based on the number
hours plate compactor is in use, and particular working
conditions. Fuel piping and connections should be replaced
every 2 years.
NOTICE