Specifications

MAYCO C30HDZ PUMP — OPERATION AND PARTS MANUAL — REV. #12 (04/03/12) — PAGE 43
MAINTENANCE (PUMP)
V-Belt And Drive Chain Adjustment
1. Loosen the pillow bearing bolts (Figure 27) only to the point
where the bolts will remain snug.
2 Unlock the two pusher bolt lock nuts.
3. Turn each pusher bolt clockwise an equal amount until the
chain is to proper adjustment of approximately 3/8 to 1/2 in.
slack in the chain. It is very important that the pulley side and
the chain side (pillow block bearings) are within 1/16” of an
equal distance.
4. This distance can be checked by using a tape measure or a
straight edge ruler, measuring from the inside of the pusher
bolt bracket to the face of the pillow block bearing.
5. The drive chain should be adjusted regularly to remove all
slack. Once all slack is removed, DO NOT over-adjust, as this
will overload the shaft bearings. A slack chain on the crank
drive creates backlash and shock loads on the shafts and
bearings which results in shorter wear/life of the drive com-
ponents.
6. Lubricate the chain regularly. Note-it is advisable to carry a
spare chain and master links for replacement in the field if
necessary.
Figure 27. V-Belt and Drive Chain Adjustment
Prior to adjusting the chain, place the
lobe of the cam in the down position.
The chain should have 83 rivets,
Including one each, half-link and full
link.
NOTE
7. Drive belts should be regularly adjusted to prevent slippage.
To adjust the belts, loosen the engine mounting bolts and
move the engine until there is a maximum 3/4 in. deflection
in the belts, retighten the engine mounting bolts.
8. Frequent inspections should be made on all drive compo-
nents to make certain that all bolts and nuts remain tight.