Specifications

WM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/09/04) — PAGE 25

WM-70 PLASTER/MORTAR MIXER — START-UP PROCEDURE

4. Turn the engine switch (Figure 14) to the ON position.

5. The main

start/stop

switch located on the engine cover

is (Figure 15) is used to start and stop the engine. Pull

this switch outward to start the engine.

6. Place the

belt slip lever

(Figure 16) in the

START/

STOP

(disengaged) position.

Figure 16. Belt Slip Lever

(Start/Stop Position)

7. Pull the

starter grip

(Figure 19) lightly until you feel

resistance, then pull briskly. Return the starter grip

gently.

Figure 19. Starter Grip

Figure 18. Drum Lock Pin (Right Position)

Figure 17. Drum Lock Pin (Side-View)

Make certain the

drum lock pin

(Figures 17

and 18) is

placed to the RIGHT (when viewing the mixer from the

towpole end) of the drum stop block which is welded to

the front side of the drum. Also make sure lock pin is

fully engaged (locked). This will prevent the drum from

tipping.

CAUTIONCAUTION

CAUTION

Figure 15. Start/Stop Switch (gasoline engine)

Figure 14. Engine ON/OFF Switch

Preventing Drum Tipping