turnigy-multistar-esc-manual

- The transmitter can set only one parameter of ESC at a time. If you want to set several parameters, please repeat the
following procedures:
- Plug the JR connector into throttle control channel of receiver.
witch “on” the transmitter and move the stick of throttle to the highest position.
- Connect the main power pack to ESC (pay attention to the polarity).
- Wait for 5 seconds, you will hear 4 beeps, that means it entered the programming mode.
- And then you will hear 5 “single beep”, then 5 “double beep”, then 5 “triple beep”, then 5 “quartet beeps” and then 5
“penta groups”. And these sounds will circulate continuously.
- Each group of 5 sounds stands for a different parameter of ESC respectively.
- You can put the stick of throttle to the lowest position during one group of 5 sounds, then the corresponding mode is saved.
- Hear 1 “ ” (Brake-Medium) or " " (Brake-Off) , then you can exit the setting mode after saving the mode.
- When the mode is saved, you can disconnect the ESC to the battery pack.
�
Hear the first “ ” in the above circulation, put the throttle stick to the lowest position, the braking mode is changed from Brake-off
into Brake-Medium. If you want to change back, please repeat the above procedures, and vice versa.
�
When you hear 5 groups “ ” or “ ” or “ ”, move the stick of throttle to the lowest position.
1 “beep”: Li-XX battery
2 “beep”: NiCd, NiMH battery
3 “beep”: LiFe battery
�
Brake
Option Parameter Assistant by Transmitter
Battery Type
Hear 5 groups “ ”or “ ” , move the stick of throttle to the lowest position.
4 “beep”: Automatically change the timing of motor（recommended for all types of motors）
5 “beep”: Timing-High（recommended for 10 (or more) poles motors and outrunner motors）
�
Timing
Note: When the timing mode of motor is saved, please adjust the motor on the ground before the flight.
Diagram for option parameter assistant by transmitter